Page 3
These hooks are a voluntary-opening device and grasping tension is adjusted by the adding of tension bands, rings, or springs (see catalog for additional information). See fillauer.com for information on other sizes of canted hooks .
Page 4
(Risk Management for Installation and Calibration) Installation The hook may be installed in any Fillauer wrist unit with a ½-20 thread. Follow the instructions provided with the wrist unit for best results. Cabling The hook “thumb” has been designed with a receiver for a ⁹⁄ ³² inch ball terminal. A triple swivel with ⁹⁄...
Page 5
However, damage caused by other manufacturers wrist units is not covered under warranty of this device. Only Fillauer tension bands, hook rings, and tension springs may be used with Fillauer hooks to adjust the grasping force of the hook.
Page 6
Serious Incidents In the unlikely event of a serious incident, seek immediate medical help and contact your prosthetist at your earliest possible convenience. Clinicians should contact their local Fillauer representative immediately in the event of any device failure.
Need help?
Do you have a question about the Hosmer 12P and is the answer not in the manual?
Questions and answers