Table of Contents
Advertisement
Quick Links
Stud Sensor
PT190306001
Please read the instruction manual carefully, and follow the
instructions contained in them. Get to know the appliance , its
correct use and the safety instructions with the assistance of
these instructions for use.
Know Your Apparatus:
This device is used to find wooden or metal studs through drywall boards.. It can
detect live wires.
Specification:
Battery power:
Depth of detecting electrical wiring
Depth of detecting metal
Depth of detecting wood
Operating temperature
Operating humidit
Position accuracy
Special Safety Instruction of use:
When using battery-powered tools, basic safety precautions, including the
following, should always be followed to reduce the risk of fire, leaking
batteries, personal injury and material damage.
Never attempt to open the battery for any reason.
Do not store the battery in locations where the temperature may exceed
0
40
C.
When disposing of batteries, follow the instructions given in the section"
protecting the environment"
Do not incinerate batteries.
Under extreme conditions, battery leakage may occur, when you notice
liquid on the batteries, proceed as follows: carefully wipe the liquid off
using a cloth. Avoid skin contact.
Protecting the environment
9V DC
50mm
30mm
19mm
0
0
-2
C ~ 45
C
80%RH
3mm
Advertisement
Table of Contents
Summary of Contents for Easy Track PT190306001
- Page 1 Stud Sensor Know Your Apparatus: This device is used to find wooden or metal studs through drywall boards.. It can PT190306001 detect live wires. Specification: Battery power: 9V DC Depth of detecting electrical wiring 50mm Depth of detecting metal 30mm...
- Page 2 If you want to dispose of the tool yourself, the battery must be removed as - Also use face or dust mask if the cutting operation is dusty. describe above and disposed of in accordance with local regulations. Place the 9.
- Page 3 After calibration has finished, slowly Caution should always be made when nailing, cutting or drilling in walls, slide the unit across wall in a floors and ceiling that may contain these items. To avoid electrical, plumbing, horizontal direction. Make sure not etc, remember that studs or joists are normally spaced 406mm or 610mm apart to tilt or lift the tool.
- Page 4 walls or thick dense walls, will not be detected. Always turn AC power off when working near wiring. The sensor is designed to detect 110 to 230 volts AC in live electrical wires. It will also detect the presence of live wires having greater than 230 volts. (5) Low battery indication The tool has low battery indication function.
Need help?
Do you have a question about the PT190306001 and is the answer not in the manual?
Questions and answers