Related Manuals for Neilsen CT0836
Summary of Contents for Neilsen CT0836
- Page 1 All manuals and user guides at all-guides.com CONCRETE MIXER CT0836 ELECTRIC MOTOR INSTRUCTION MANUAL Please keep this instruction manual for future reference...
-
Page 2: Declaration Of Conformity
We, the importer CANNON TOOLS LTD Add: 20 station road, Rowley Regis, west midlands,B65 0 JU.U.K. Declare that the product concrete mixer NO.CT0836 Are in conformity with the following Directives to the specification Under which conformity is declared. The low voltage Directive (2006/95/EC) - Page 3 All manuals and user guides at all-guides.com CT0836 Voltage 230V Frequency 50Hz Power 550W Capacity 180L Motor speed 1380 rpm Mix speed 28-30rpm WARNING You must always wear the following if operating this power tool. Wear goggles. Wear ear defenders.
- Page 4 All manuals and user guides at all-guides.com SAVE THIS MANUAL You will need the manual for the safety warnings and precautions, assembly instructions, opening and maintenance procedures, parts list and dia gram. Keep your in voice with this manual. Write the invoice number on the inside of the front cover.
- Page 5 All manuals and user guides at all-guides.com 18. Keep safe clearance aroun d mixer. Keep all person s (except operator) a minimum of six feet from the mixer during operation. 19. Do not overload mixer. An overload could damage equipment. 20.
- Page 6 All manuals and user guides at all-guides.com Put the pillar in the connector - the holes should be in one line. 16) Put the bolt through the hole on one side, th en the washer and the nut from the other side and tighten with a wrench.
- Page 7 All manuals and user guides at all-guides.com 18) In sert bolt throug h holes fr om one side, then wash er and nut from the other side and tighten with a wrench. With two people rai e the drum and pull out the upper part as shown i n the photo below.
- Page 8 All manuals and user guides at all-guides.com 20) Put the seal in upper drum. Bolts should be pl aced vertical and then tighten with a s rewdriver. The drum with placed seal we put on lower drum (this one with ring beam) The arrows should be placed across, as show in the photo.
- Page 9 All manuals and user guides at all-guides.com 22) Using the b olt set no 5, and wheel of the heeling, we screw the bolt from th e bottom, and from the top we put spring and stopper. this bolt should be screw 23) Mount the motor cove o the pillar, on which the wheels are.
- Page 10 All manuals and user guides at all-guides.com motor pillar 25) Pu t the wheel in the motor cover, placing the pin in wheel centre. and screw with bolt Mount wedge belt on th e wheel, mount the motor to motor pillar.
-
Page 11: Operation
All manuals and user guides at all-guides.com REMEMBER !! THE WEDGE BELT MUST BE STRAINED ! YOU CA N DO IT GOVERNING THE MOTOR PILLAR Set up motor cover, resp ectively connecting cords: - yellow-green screw to motor cover - blue to upper input - brown to lower input OPERATION Place the Cement Mixer on a solid surface. - Page 12 All manuals and user guides at all-guides.com...
- Page 13 All manuals and user guides at all-guides.com...
- Page 14 All manuals and user guides at all-guides.com CANNON TOOLS LTD Add: 20 station road, Rowley Regis, west midlands,B65 0 JU.U.K. Made in China...