Table of Contents
Advertisement
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Trigger is in the off-position before performing any procedure in this section.
Charging
NOTE: Before using tool for the first
time, fully charge the Battery.
1. Plug the Charger into a grounded,
120VAC, 60Hz receptacle.
2. Plug the Charger Plug into Charging Port.
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
General Operating Instructions
NOTE: Before using tool for the first
time, fully charge the Battery.
1. Place proper hex bit into the Chuck.
2. To switch between straight grip and pistol
grip, push Handle Lock forward, adjust
Handle, then lock Handle Lock.
Page 6
For technical questions, please call 1-888-866-5797.
3. The Charging Light will glow red during charging
and turn off when charged. Unplug the Charger
and disconnect it from the tool when finished.
Note: Do not leave the Battery in a discharged state.
Charge the Battery every 3 months if the Cutter
is not in use. This will keep the Battery from
wearing down and add to its life. Do not charge
the tool at temperatures below 40° F.
2. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
3. Direction Switch:
a. Push to the left for clockwise rotation.
b. Push to the right for counterclockwise rotation.
4. Press Trigger to operate tool.
5. To activate flashlight, use Flashlight Switch.
6. To prevent accidents, move Direction Switch
to center position after use. Clean, then store
the tool indoors out of children's reach.
Item 64313
Advertisement
Table of Contents
