Tape Adjustments - Sanyo MCD-Z260F Service Manual

TAPE ADJUSTMENTS

a. Adjusting Azimuth
Be sure to clean the heads before attempting to make any adjustment.
Be sure both channel's waveform are the same for the phase matching.
Be sure both channels (1 and 2) are the same level using a dual-channel oscilloscope.
After completion of the adjustment, apply the threadlock (TB-1401B) to the azimuth adjustment screws to fix them securely.
Load an azimuth adjustment test tape (VT-f-703 etc., 10 kHz)
in tape deck.
Press the PLAY button.
Use a cross-tip screwdriver to turn the screw for azimuth
adjustment so that the left and right outputs are maximized.
Press the STOP button.
b. Replacing the Head
After replacing the head, demagnetize the head by using a
l
degausser.
All wiring should be returned to the original position after work is
l
completed.
c. Replacing the Motor
e. Checking the Mechanism Torques
Clean the head, capstan and pinch roller before making any measurement.
l
Measurement
Cassette for
measurement
FEW
All manuals and user guides at all-guides.com
d. Adjusting Tape Speed
Use a plastic screwdriver for adjustment.
l
(1) Inset the test tape (Ml-f-1 11 N etc., 3000 Hz).
(2) Press the PLAY button.
(3) Use a flat-tip screwdriver to turn the SVR to adjust so that the frequency
counter becomes 3000 Hz.
Take-up torque Back tension
PLAY: TW-2111A
1.5-4.5 gr.cm
30-60 gr.cm
R/P HEAD
YELLOW
WHITE
RED EARTH
'MOTOR SPEED ADJ.
Tape tension
Drive-power cassette
60 gr or more