Gatekeeper Systems CartManager XD+ Owner's/Operator's Manual page 19

Hide thumbs Also See for CartManager XD+:
Table of Contents

Advertisement

Quarterly Maintenance:
1.
Clean the battery cables and connectors:
Put on rubber gloves and safety goggles.
Disconnect the battery cables from one of the main batteries and remove the battery from the CartManager
XD+.
Clean the terminals with a solution of 1 tbsp of baking soda to one cup of warm water.
Use a wire brush or medium sandpaper to remove any corrosion or buildup.
While the battery is out, buff the cable connectors down to bare metal with sandpaper, a wire brush or a wire
wheel.
Use a clean dry cloth to wipe the connectors and terminals.
Replace the battery, reconnect cables and tighten all connections.
Spread a thin layer of waterproof grease over the terminals and connectors.
Replace the plastic terminal covers.
Repeat this process for the next battery.
2.
Check each battery for leaks or cracks in the casing. If there is any fluid leaking from a battery, it should be
replaced immediately. See Replacing the CartManager XD+ Batteries on page 28.
3.
Check all fasteners and hardware. Tighten any loose items.
4.
Apply axle grease to the rear swivel wheel bearings.
CartManager XD+ Owner-Operator Training and Troubleshooting Guide
Page 16

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CartManager XD+ and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents

Save PDF