Page 1
User Manual DC01 GTIN9346376063944 Superlite Electric Foldable Wheelchair...
Page 2
You will find the operation and care of your Superlite Electric Foldable Wheelchair simple and easy. Disclaimer:JBH and Peak Care Equipment cannot be held responsible for personal injury or property damage resulting from the unsafe or improper operation or maintenance of Superlite Electric Foldable Wheelchair.
18 Right Coupling Rod 11 Top Controller Assembly 5 Battery Rear Holding Assembly 12 Right Armrest Assmebly 19 Right Armrest Support 6 Push Lever 20 Enforcement Rod 13 Battery 7 Left Armrest Assembly 14 Foot Pedal 21 Motor Fixing Support V20-04-DC01...
The Superlite Electric Foldable Wheelchair is designed for use on firm, even surfaces such as concrete and indoor surfaces. Do not operate the Superlite Electric Foldable Wheelchair on sand, loose soil or over rough terrain, which could damage wheels, bearings, axles and motors, or loosen fasteners. V20-04-DC01...
Do not exceed the weight limited total of 120 kgs for rider plus any items. Do turn off the Superlite Electric Foldable Wheelchair when exiting the chair for safety. Do practice driving the Superlite Electric Foldable Wheelchair in a private, enclosed area. Please do not drive the wheelchair on public road. V20-04-DC01...
Page 9
B. Using the correct tools, tighten any fasteners that become loose as soon as possible. ◎ Change and Adjustments Never use non- Superlite Electric Foldable Wheelchair parts or make changes. Doing so will void the warranty and may create a safety hazard. V20-04-DC01...
Seat cushion To expand the Superlite Electric Foldable Wheelchair grasp the push bar and pull up while holding down on the seat to expand the chair and complete the assembly: Push down seat to expand Grasp push bar V20-04-DC01...
Page 11
Connect the controller wire harness to the CPU wire harness. Take care the line up the pins properly as arrow tip indicate so that they do not get bent, broken or damaged. Note Make sure connector pins “white arrow” to “white arrow” . V20-04-DC01...
Page 12
Please keep the charging port side ( Panel with warning sticker ) of battery face to ground. Keep this side face down to the ground while inserting battery. Take out battery by holding the strip of battery pulling out by hand. Make sure batteries are slotted into holder completely for proper power connection. V20-04-DC01...
◎ Procedure for wheelchair unfolding Unfold food pedal first. Hold the top of backrest with one hand and the other hand holding the front end of the seat. 3. Both hand push away till a “Click” sound heard for completely unfold the wheelchair. V20-04-DC01...
When operating in reverse: A. Operate the wheelchair slowly and at an even speed. B. Stop often and check to make sure your path is clear of obstacles. V20-04-DC01...
First charging method ◎ Charge both batteries at the same time via controller charge port. Turn the power off. Plug in the charger to the controller port. Connect the charger cable first, then turn the power on. V20-04-DC01...
Use the secondary charger pigtail to adapt the battery charger to plug into the battery directly. Immediatly unplug charger from power source as soon Caution as indicating light on charger turns green. V20-04-DC01...
Page 17
Store the battery in a room temperature environment that is kept dry. d. Avoid temperature extremes and do not allow the battery to freeze. Do not attempt to charge your battery if it is frozen from extreme weather conditions, instead first allow it to thaw for several hours. V20-04-DC01...
(male) on Why can’t I connect the misaligned with connec- the controller to align controller? tor holes (female) on the with holes (female) on CPU connector. the CPU connector. V20-04-DC01...
2nd red lights flash indicates no signal to joystick. 3rd red lights flash indicates the wheelchair is charging. 4th red lights flash indicates sufficient power to operate. 5th red lights flash indicates the brake solenoid is not connected or is damaged. V20-04-DC01...
6. Products that have been improperly stored. 7. Products that have been improperly handled. 8. Products that have been improperly operated. 9. Products that have experienced general misuse. 10. Products that have been modified in an unauthorized or unapproved way. V20-04-DC01...
Need help?
Do you have a question about the DC01 and is the answer not in the manual?
Questions and answers