Feider Machines FG3000-1 Instruction Manual
  1. Manuals
  2. Brands
  3. Feider Machines Manuals
  4. Inverter
  5. FG3000-1
  6. Instruction manual

Feider Machines FG3000-1 Instruction Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
ORIGINAL INSTRUCTION > EN
Gasoline Generator
Instruction Manual
Model: FG3000-1
Feider France
32, rue Aristide Bergès - ZI 31270 Cugnaux - France
Made in PRC
Warning: Please read the manual carefully before using the unit!
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FG3000-1 and is the answer not in the manual?

Questions and answers

Summary of Contents for Feider Machines FG3000-1

  • Page 1 ORIGINAL INSTRUCTION > EN Gasoline Generator Instruction Manual Model: FG3000-1 Feider France 32, rue Aristide Bergès - ZI 31270 Cugnaux - France Made in PRC Warning: Please read the manual carefully before using the unit!

  • Page 2: Table Of Contents

    CONTENTS 1. SAFETY INSTRUCTION 2. COMPONENT IDENTIFICATION 3. CONTROLS 1) Engine Switch 2) Recoil Starter 3) Fuel Valve 4) Choke 5) Circuit Breaker 6) Ground Terminal 7) Oil Alert System 4. GENERATOR USE 1) Connections to a Building's Electrical System 2) Ground System 3) AC Applications 4) AC Operation...

  • Page 3: Safety Instruction

    1. SAFETY INSTRUCTION Warning: 1. Attention! Exhaust gases are toxic. Do not operate the generator in a room without ventilation system! 2. Children should be protected by keeping them at a safe distance from the generator set! 3. Refilling of the generating sets are not allowed during the operation! 4.
  • Page 4 • Run the generator in respect of the power indicated in the user’s manual. Do not run the generator with an overload or at excessive speed. • The silencer of the generator becomes extremely hot when the motor runs or even for a time after it has stopped.
  • Page 5 • Engine exhaust gases are toxic. Do not operate the generating set in unventilated rooms. When installed in ventilated rooms, additional requirements for fire and explosion protection shall be observed. • Before use, the generating set and its electrical equipment (including lines and plug connections) should be checked to ensure that they are not defective.
  • Page 6 • Make sure that the fuel cap is tightly closed before starting. • Do not keep petrol in the tank for a long time. • While using or transporting the generator, make sure you keep the generator upright, otherwise the fuel may escape from the carburettor or the fuel tank.
  • Page 7 • You must periodically check the silencer (Before doing this, switch off the generator and let it cool completely). A damaged silencer increases noise. • Do not throw motor oil into the drains but deposit it at a collection point set up for that purpose. •...

  • Page 8: Component Identification

    Keep away from the machine Exhaust emissions are harmful to health of body No naked fire near the machine! Do not connect with the electricity system. Danger ! Electrical shock ! 2. COMPONENT IDENTIFICATION Fuel tank Circuit breaker Fuel valve Choke socket level...

  • Page 9: Controls

    3. CONTROLS 1) Engine Switch To start and stop the engine. Switch position: OFF: To Stop the engine. Key can be removed/inserted. ON: To run the engine after starting. START: To start the engine by turning the starter motor. With Electric Starter Without Electric Starter Return the key to the ON position once the engine has started.
  • Page 10 4) Choke The choke is used to provide an enriched fuel mixture when starting a cold engine. It can be opened and closed by operating the choke lever or choke rod manually. Move the lever or the rod to the CLOSE position to enrich the mixture. 5) Circuit Breaker The circuit breaker will automatically switch OFF if there is a short circuit or a significant overload of the generator at the receptacle.

  • Page 11: Generator Use

    7) Oil Alert System The oil alert system is designed to prevent engine damage caused by an insufficient amount of oil in the crankcase. Before the oil level in the crankcase can fall below a safe limit, the oil alert system will automatically shut down the engine (the engine switch will remain in the ON position).
  • Page 12 Special Requirements There may be Federal or State Occupational Safety and Health Administration (OSHA) regulations, local codes, or ordinances that apply to the intended use of the generator. Please consult a qualified electrician, electrical inspector, or the local agency having jurisdiction. •...
  • Page 13 4) AC Operation ①Start the engine ②Switch the AC circuit breaker ON. ③ Plug in the appliance. Most motorized appliances require more than their rated wattage for startup. Do not exceed the current limit specified for any one receptacle. If an overloaded circuit causes the AC circuit breaker to switch OFF, reduce the electrical load on the circuit, wait a few minutes and then reset the circuit breaker.
  • Page 14 2) Connect the positive (+) battery cable to the battery positive (+) terminal. 3) Connect the other end of the positive (+) battery cable to the generator. 4) Connect the negative (-) battery cable to the battery negative (-) terminal. 5) Connect the other end of the negative (-) battery cable to the generator.

  • Page 15: Pre-Operation Check

    High altitude performance can be improved by installing a smaller diameter main fuel jet in the carburetor and readjusting the pilot screw. If you always operate the engine at altitudes higher than 5000 feet (1500 meters) above sea level, have an authorized generator dealer perform this carburetor modification.
  • Page 16 2. Check the oil level by inserting the dipstick into the filler neck without screwing it in. 3. If the level is low, add the recommended oil to the upper mark on the dipstick. 2) Fuel Recommendation 1. Check the fuel level gauge. 2.
  • Page 17 Occasionally you may hear light “spark knock" or “pinging" (metallic rapping noise) while operating under heavy loads. This is no cause for concern. If spark knock or pinging occurs at a steady engine speed, under normal load, change brands of gasoline.

  • Page 18: Starting/Stopping The Engine

    Oxygenated fuels can damage paint and plastic. Be careful not to spill fuel when filling your fuel tank. Damage caused by spilled fuel is not covered under warranty. 6. STARTING/STOPPING THE ENGINE Starting the engine 1. Make sure that the AC circuit breaker is in the OFF position. The generator may be hard to start if a load is connected.

  • Page 19: Maintenance

    In normal use: 1. Turn the AC circuit breaker to the OFF position. Disconnect the DC battery charging cables. 2. Turn the engine switch to the OFF position. 3. Turn the fuel valve to the OFF position. 7. MAINTENANCE Good maintenance is essential for safe, economical, and trouble-free operation. It will also help reduce air pollution.
  • Page 20 WARNING Improper maintenance, or failure to correct a problem before operation, can cause a malfunction in which you can be seriously hurt or killed. Always follow the inspection and maintenance recommendations and schedules in this owner's manual. The maintenance schedule applies to normal operating conditions. If you operate your generator under severe conditions, such as sustained high-load or high-temperature operation, or use it in unusually wet or dusty conditions, consult your servicing dealer for recommendations applicable to your individual needs and use.
  • Page 21 CAUTION Used motor oil may cause cancer if repeatedly left in contact with the skin for prolonged periods. Although this is unlikely unless you handle used oil on a daily basis, it is still advisable to thoroughly wash your hands with soap and water as soon as possible after handling used oil.
  • Page 22 5) Fuel Sediment Cup Cleaning The sediment cup prevents dirt or water which may be in the fuel tank from entering the carburetor. If the engine has not been run for a long time, the sediment cup should be cleaned. 1) Turn the fuel valve to the OFF position.

  • Page 23: Transporting And Storage

    4) Visually inspect the spark plug. Discard it if the insulator is cracked or chipped. Clean the spark plug with a wire brush if it is to be reused. 5) Measure the plug gap with a feeler gauge. Correct as necessary by carefully bending the side electrode.
  • Page 24 WARNING Contact with a hot engine or exhaust system can cause serious bums or fires. Let the engine cool before transporting or storing the generator. Take care not to drop or strike the generator when transporting. Do not place heavy objects on the generator.
  • Page 25 The fuel of this machine is combustible and deflagrating. After the machine has been shut down, the additional fuel must be treated properly and the local environmental requirements must be met. 2) Change the engine oil 3) Remove the spark plug, and pour about a tablespoon of clean engine oil into the cylinder. Crank the engine several revolutions to distribute the oil, then reinstall the spark plug.

  • Page 26: Troubleshooting

    9. TROUBLESHOOTING When the engine will not start: Is there fuel in the tank? Refill the fuel tank Is there oil in the tank? Add the recommended oil. STILL SPARK Is there spark from Replace the Take the generator to an spark plug.
  • Page 27 No electricity at the AC receptacles Is the AC circuit breaker ON Turn the AC circuit breaker ON Check the electrical appliance or Take the generator to an DEFECTS equipment for any defects. authorized generator dealer. Replace the electrical appliance DEFECTS or equipment.
  • Page 28 10. CIRCUIT DIAGRAM...

  • Page 29: Specifications

    11. SPECIFICATIONS Engine Engine model LT208 Engine type Single cylinder, 4-strokes, Forced air cooling, OHV. Displacement( CC) 208cc Rated speed 3000/min Igniting system Transistor magneto Starting system Recoil Fuel Volume (L) 15 L Continuous operation time (h) 10 h Min. Fuel consumption (g/kW.h) 360 g/kW.h Lube.
  • Page 30 Warranty We guarantee this product for 2 full years. The warranty period for this item starts on the day of purchase. You can prove the date of purchase by sending us the original receipt. We insure over the entire warranty period: •...

  • Page 31: Ec Declaration

    Declaration of conformity FRANCE FRANCE ZI, 32 RUE ARISTIDE BERGES – 312070 CUGNAUX – FRANCE Declares that the machinery designated below: Gasoline Generator FG3000-1 Model: Serial number: 20200210947-20200211346 Complies with the provisions of the Directive “machinery” 2006/42/CE and national laws transposing it:...

This manual is also suitable for:

Fg3000

Table of Contents