Nedlands Group EMS-PRO Installation And Operation Manual

INSTALLATION AND OPERATION MANUAL
SAFETY PRECAUTIONS
In Australia and New Zealand, only licensed electricians are permitted by law to work with electrical installations.
The Installer is responsible for ensuring compliance with all relevant building and safety codes and regulations i.e. AS3000 and AS2293.1.
DO NOT INSTALL OR CONNECT THIS PRODUCT UNLESS YOU ARE A LICENSED ELECTRICIAN.
ISOLATE THE ELECTRICAL SUPPLY BEFORE INSTALLING, DECOMMISSIONING OR REPLACING THIS FITTING.
DO NOT TOUCH THE TERMINALS WHEN THE LIGHT FITTING IS ENERGISED.
PLEASE DO NOT TAMPER OR MODIFY THIS FITTING. DOING SO WILL VOID WARRANTY.
APPLICATION
This LED Emergency luminaire is intended for connection to an unswitched
active supply. When mains power is available, the LED lamp does not
illuminate but the green charge indicator LED comes ON. Mains power
provides continuous charge to the rechargeable batteries. When mains is
disrupted, the LED lamp receives supply from the internal batteries and
illuminates automatically.
TECHNICAL SPECIFICATIONS
Model EMS-PRO
Input Voltage
230VAC 50/60Hz
Light Source Twin High Performance LEDs
Battery SYNTHIUM™ LiFePO4
Autonomy
> 120 minutes
Mounting Recessed - Cutout: 75mm - 150mm
Temperature
0°C - 40°C
IP Rating
IP20
Mode Non-Maintained
Material
Flame Retardant Polycarbonate
Classification
C0 D80 C90 D80
Warranty 3 years
INSTALLATION
1. Unpack the fitting and inspect for any visible
damage. If damage is found, repack the
goods and return it to your point of sale for
replacement.
2. Mark the position of the fitting at the desired
ceiling location and provide a 75mm-150mm
diameter cutout.
3. Pass the inverter and battery pack through the
cutout and secure it against a solid structure e.g. beam or truss using screws.
4. Connect the inverter pack to the LED disc.
5. Guide the supplied flex cable through the cutout and conect the plug to mains power.
6. Then, pull back the two spring clips and release once it gets through. Ensure that the fitting is secure and
flush against the ceiling.
7. Once mains supply is present, only the green charge indicator LED will energise and remain lit. Allow a few
minutes for the battery to receive a small charge, then press and hold the test switch for a few seconds and
observe the LED lamp illuminating on emergency mode.
8. Under normal operating conditions, the emergency function will trigger automatically upon loss of supply to
the normal lighting circuit.
Recessed Disc
Ø160
Controller
CONTROLLER
Ø75 - 150mm cutout
35
Ø100
FIGURE 1
220 - 240VAC
FIGURE 2