Advertisement
SAFETY INFORMATION
• Follow workshop health & safety rules,
regulations and conditions when using the
rechargeable site lamp.
• When not in use, rechargeable site lamp
should be stored in a dry location to inhibit
rust.
• During their period of use, accessories must be
checked for wear, cracks and other damage,
replace any damaged or worn parts.
• Use genuine parts only. Unauthorized parts
may be dangerous and will void the warranty.
• Keep the rechargeable site lamp clean and
in good working order for best and safest
performance.
• DO NOT use the lamp in the immediate vicinity
of inflammable materials or gases.
• DO NOT point the light directly in your own or
any other person's or animal's eyes.
• DO NOT pull the charger plug from the mains
socket by the lead.
• DO NOT drop, throw or abuse the
rechargeable site lamp.
WARNING!
• DO NOT use any other type of charger with
this product, other than the supplied mains
or car charger. Failure to observe this warning
could result in injury and or fire and will void
the warranty.
PACKAGING CONTENT
DESCRIPTION
Rechargeable site lamp
Universal AC Adaptor
O.I.P.M.
BEFORE INSTALLATION
• Eyes protection: Wear a protective mask or
protective eyewear.
• Check that the product has not suffered any
damage during transport or storage. Clean and
remove any dust or residual packing material.
• Read the instructions carefully before using
rechargeable site lamp and keep them for
further reference.
WARNING!
• Defective accessories can lead to personal
injury and material damage.
INSTALLATION
Refer "EXPLODED VIEW"
1. Place the site lamp on a plane surface and
open the charging socket cover (11) located on
the rear of the light just below the switch (8).
2. Connect charging lead to the socket in the
back of light. Connect charger to power
supply, switch on power supply. The battery
will begin charging, full charge will be reached
in approx. 4.5hrs.
2
3. The three LED lights near the charging socket
cover (11) shows the state of charge of the
battery while charging.
4. When the battery is fully charged, remove the
charger and close the charging socket cover
(11). (A USB port is also position next to the
charging connection so that the battery can be
used as a power bank.)
CAUTION!
• Use only the supplied charger plug for
connecting lamp to the power supply.
• DO NOT turn the lamp on when it is being
charged.
• DO NOT attempt to open, disassemble, modify
or service the battery pack.
• DO NOT expose rechargeable site lamp to
temperatures above 60°C (140°F).
• DO NOT use the lamp if you suspect that the
battery or the lamp casing is damaged.
• DO NOT leave battery in a discharged state,
recharge battery immediately. Before storage,
fully recharge the battery, subsequently
recharge the battery at least once every six
months of non-use.
OPERATING INSTALLATION
(Refer "EXPLODED VIEW")
1. Press the switch (8) once for low, twice for
medium and three times for high lumens
output.
2. The site lamp can swivel through 360° and be
tilted
QTY.
MAINTENANCE
1
• Recharge the battery immediately when
1
discharged.
1
• Before storage, fully recharge the battery,
subsequently recharge the battery at least
once every six months of non-use.
• When not in use, rechargeable site lamp
should be stored in a dry location.
Advertisement
