CONTENTS Getting Started Important Safety Instructions Polarization Instructions State of California Proposition 65 Warnings Description of the Vacuum Assembling the Vacuum Operation Reclining the Handle On/Off Switch Edge Cleaning Automatic Carpet Height Adjustment Bare Floor Cleaning Maintenance and Care Power Cord Care Vacuuming Under Furniture Replacing the Vacuum Bag Removing/Reinstalling the Bottom Plate...
• Do not use without vacuum bag in it to your Authorized DAVID Vacuum place. Retailer for service. • Turn off all controls before unplugging. • Do not pull or carry by cord, use cord •...
POLARIZATION INSTRUCTIONS Power Cord, 2-Wire Polarized Cord To reduce the risk of electric shock, the charger is equipped with a polarized alternating current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug.
ASSEMBLING THE VACUUM Attaching the Handle to the Vacuum NOTE: Do not plug in the vacuum until it is completely assembled. The vacuum cleaner and the handle are packed separately and require assembly. • Thread the cord through the lower and upper cord guides on the back of the vacuum bag (Fig.
OPERATION This vacuum is intended for household use only. Reclining the Handle • Press the handle release pedal located on the back of the vacuum with your foot to recline the handle (Fig. 1). On/Off Switch • The power switch located on the vacuum handle, is a three-way switch Fig.
Power Cord Care • If the cord or plug has any apparent damage, refrain from using the vacuum. Please visit an Authorized DAVID Vacuum Retailer for a new cord or plug. • When the vacuum is in use, hold the cord to keep from running over it.
MAINTENANCE AND CARE Replacing the Vacuum Bag NOTE: Unplug the vacuum cleaner from the electrical outlet before changing the bag. • Unzip the bag compartment. • Remove the used vacuum bag by pulling the green bag collar tab away from the vacuum (Fig. 1). Slide the used bag out of the bag holder which automatically seals the bag opening Fig.
MAINTENANCE AND CARE Removing and Reinstalling the Bottom Plate WARNING! To Reduce the Risk of Electrical Shock or Injury From Moving Parts, Unplug Before Servicing or Cleaning. To Remove the Bottom Plate: • Press the handle release pedal to place the vacuum cleaner in the flat position. •...
• Reinstall the bottom plate (see page 9). Lifetime Belt Protection Warranty (Model S10P.DV) Your vacuum belt is covered with a Fig. 2 lifetime warranty. Should the vacuum belt break, simply bring your vacuum to your Authorized DAVID Vacuum Retailer for a free replacement.
• If the brushroll is free of obstructions and the Brushroll Jam Indicator light is still flashing, it’s likely the clogged condition is located in the vacuum motor fan. If so, please take your vacuum to an Authorized DAVID Vacuum Retailer for service.
Annual Checkup To keep your vacuum in peak operating condition, it is recommended you bring it to an Authorized DAVID Vacuum Retailer for an annual checkup. The retailer will conduct a comprehensive examination to ensure your vacuum is in...
Install bag properly. Review from vacuum properly bag installation (page 8) Any other service should be performed by an Authorized DAVID Vacuum Retailer. To locate your nearest Authorized DAVID Vacuum Retailer, visit our website at www.DAVIDSVACUUMS.COM or call 281-866-0027. Key Replacement Parts Genuine HEPA bags and belts are available from your authorized DAVID retailer.
The original product, as described above, and/or non-wearable parts deemed defective, in David’s Vacuums’ sole discretion, will be repaired or replaced for the duration of the warranty period. If found to be defective within the stated warranty period, the unit will be repaired at no charge to you (both parts and labor) by an authorized David’s Vacuums Service Center.
Page 17
4. Consequential and incidental damages. 5. Defects caused by repair persons not authorized by David’s Vacuums. These defects include damages caused in the process of shipping, altering, or repairing your David’s Vacuums product (or any of its parts) when the repair is performed by a repair person not authorized by David’s Vacuums.
Need help?
Do you have a question about the D2000 and is the answer not in the manual?
Questions and answers
How do you fix the handle release pedal? It completely fell off. In one piece
what type of filter bags does the D2000 use
The DAVID D2000 uses self-sealing HEPA bags. Using non-genuine David’s Vacuums parts, including bags, is not recommended and may void the warranty.
This answer is automatically generated