Davis Instruments Wheel a Weigh Quick Start Manual

ASSEMBLY INSTRUCTIONS

This hardware allows these wheels to be installed on
almost any boat with a hard transom of 12" (30 cm) high
or more.
EXTERIOR
of inflatable
Template provided
with kit
Rubber
Gasket
Transom
Bolt
TRANSOM BRACKET KIT
For use with Launching Wheels for
Inflatables #1487 and #1488
TRANSOM
INTERIOR
of inflatable
Rubber
fused to
3/8" Drill
Washer
Holes
1. Position the left and right struts on the transom,
wheels facing out and spread well apart to provide
lateral stability.
2. Mark the center of hole "TOP" for both struts or cen-
ter in the hole that may already be there. It is impor-
tant that the weight is carried by the strut brackets,
not by the knob assemblies.
3. Using the template printed on the next page of this
document, align hole "TOP" with the the left-hand
mark on the transom. Make certain that the strut as
outlined on the template is vertical. Mark the "LEFT"
Nut
hole. Repeat for the right-hand strut and mark the
"RIGHT" hole.
Gasket
4. Drill through the transom at "RIGHT" and "LEFT"
using a 3/8" (9.5 mm) drill.
Steel
5. Assemble the transom hardware as shown in drawing
below. Bolt into place.
6. With everything positioned, check the alignment of
hole "TOP" and drill using a 3/8" (9.5 mm) drill.
3465 Diablo Avenue, Hayward, CA 94545, U.S.A.
Phone (510) 732-9229 • Fax (510) 732-9188
For information about our other fine products, visit
info@davisnet.com
www.davisnet.com
1489_Ins.pdf October 2005
#1489