Advertisement
D1 USER MANUAL
INDEX
(CLICK TO NAVIGATE TO PAGE)
PAGE
1
2
3
4
5
6
Please note that any printed or downloaded User Manuals may not reflect the most current revisions.
The information contained in these materials is subject to change.
For the most current information available, visit vpc.com.
04/07/21
Advertisement
Table of Contents
Summary of Contents for VPC D1
- Page 1 MODULE INSTALLATION AND REMOVAL STRAIN RELIEF ASSEMBLY Please note that any printed or downloaded User Manuals may not reflect the most current revisions. The information contained in these materials is subject to change. For the most current information available, visit vpc.com. 04/07/21...
- Page 2 The D1 receiver is equipped with guide bushings (Figure B). These bushings accept the guide pins of the ITA frame. Figure A. D1’s module installation side, indicated by the in-set face for the module. NOTE: More information on module installation is provided on page 5 of this User Manual.
- Page 3 0.025” [.635 mm]. Torque the screws to 6.5 in-lbs [0.73 Nm]. NOTE: The guide bushings are positioned off-center to prevent engagement The D1 receiver frame is designed to be used in a modular mismatch. configuration. As long as the minimum distances between...
- Page 4 Using the Phillips head screwdriver, fasten the strain relief to the back Refer to page 6 for instructions on how to perform these steps. (wiring) side of the D1 receiver with the 2-56 screws and nuts provided NOTE: If the application requires, receiver modules can be installed in the ITA (Figure A).
Need help?
Do you have a question about the D1 and is the answer not in the manual?
Questions and answers