Related Manuals for Dakota Alert PIR-4000
Summary of Contents for Dakota Alert PIR-4000
- Page 1 Dakota Alert WIRELESS SECURITY EQUIPMENT Wireless PIR Senor PIR-4000 USER GUIDE www.dakotaalert.com...
-
Page 2: Package Contents
The PIR-4000 transmitter is compatible with all Dakota Alert 4000 series receiv- ers. The PIR-4000 is designed for indoor applications or outdoor applications in a protected area such as an eve. When the sensor detects an object it will send a signal to a receiver which will sound one of the selected tunes for few seconds. -
Page 3: Front View
FRONT VIEW SIDE VIEW... - Page 4 ADJUSTING MOTION DETECTOR SETTINGS To adjust your settings, move the jumpers inside the motion detector’s case to complete a circuit. 1. To open the case, locate the small tab on the bottom of the case and press with a small flat screwdriver while pulling the lens portion of INSERT FLAT SCREWDRIVER IN TAB...
- Page 5 3. Gently pull off the jumper for the setting you want to change. Note: If you can’t move the jumper with your fingers, you can use a tweezers. 4. Gently slide the jumper back onto the pair of jumper pins that corresponds with the setting you want.
-
Page 6: Jumper Settings
JUMPER SETTINGS • RESET: Changes the minimum time between alarm activations. 120S (120 Seconds): 10S (10 Seconds): Waits 120 seconds before Waits 10 seconds before 120S 120S the alarm activates again the alarm activates again • LED: Turns LEDs on or off OFF: LED lights for 2 Turns off LEDs... -
Page 7: Installing The Battery
1. Open the case by pressing the small tab at the bottom of the case with a small screwdriver. 2. Connect a CR-123A battery (included) to the PIR-4000. Be sure to observe the polarity (+/-) on the case. Battery 3. Replace the cover... - Page 8 CODING TO YOUR RECEIVER NOTE: You can connect up to 16 transmitters to your receiver 1. Refer to the manual for you Dakota Alert 4000 Series receiver for complete coding instructions. Test Button 2. To activate the PIR-4000 either wave your hand over...
- Page 9 MOUNTING YOUR PIR-4000 NOTE: For maximum range between the motion detector and receiver, avoid mounting the sensor on a metal object. Although the maximum range is about one mile, obstructions such as hills, trees, metal siding and stucco can reduce that range.
-
Page 10: Specifications
Time). We will be happy to answer you questions and help you in any way we can. WARRANTY Dakota Alert warrants this product to be free of defects in materials and workmanship for a period of one year from the date of purchase. This warranty does not cover damage resulting from accident, abuse, act of God, or improper operation. -
Page 11: Legal Notices
LEGAL NOTICES This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) the device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly ap- proved by the party responsible for compliance could void the users authority to operate the equipment. - Page 12 Dakota Alert, Inc. www.dakotaalert.com Dakota Alert Phone: (605)356-2772 WIRELESS SECURITY EQUIPMENT Fax: (605)356-3662 Address: 32556 477th Ave. PO Box 130 Elk Point, SD 57025...