ETEKCITY EAC-88 Quick Start Manual

WARRANTY
Etekcity Corporation warrants all products to be of the
highest quality in material, craftsmanship, and service,
effective from the date of purchase to the end of the
warranty period. Warranty lengths may vary between
product categories.
CUSTOMER SUPPORT
Etekcity Corporation
1202 N. Miller St., Suite A
Anaheim, CA 92806
Email: support@etekcity.com
Toll-Free: (855) 686-3835
Support Hours
Mon–Fri, 9:00 am–5:00 pm PST/PDT
JJ0120MC-Q1.1_0919EAC-88
HAIR PULLED
OR STUCK?
• If the curler pulls on your hair at the roots:
• Pull the curler in the direction of the ends of your
hair.
• Make sure your hair and the curler are in the right
position (see Using Your Curler).
• If the curler still pulls on your hair, follow the
numbered steps below to release your hair.
• If your hair is stuck in the curler:
Release the Rotate Button.
1.
2. Turn the curler off.
3. Pull the curler straight down. If hair is stuck firmly,
you may need to use some force.
4. After hair is released, turn on the curler and press
the Rotate Button to allow the heating plates to
rotate back to the correct position.
CAUTIONS
Do not put too much tension on the cord.
410F 410F 410F
350F 350F 350F
300F 300F 300F
OFF OFF OFF
Curler must be OFF when plugged in, or it will not turn on.
Instant Auto Curler
Model: EAC-88
Q U I C K S TA R T G U I D E
CURLING GUIDE
• There are many ways to use this curler. Here are
starter settings tested by Etekcity engineers.
• This chart is for reference only. Adjust based on your
actual results.
Loose Curl Classic Tight Curl
Curl
Thin Hair
300°F for 350°F for 350°F for
10 seconds 10 seconds 15 seconds
Medium
Hair 410°F for 5 410°F for 410°F for
seconds 10 seconds 15 seconds
Thick Hair
410°F for 410°F for 410°F for
10 seconds 15 seconds 20 seconds