Häfele 833.02.610 Assembly Manual

Assembly guide
Components
Component parts
1 x LED strip light
Before you start...
Helpline on 01788 548800 and our team will get things sorted. When you are ready to start make sure you have the
right tools to hand, plenty of space and a clean dry area for building. Don't rush, read the instr
through the sequence before you begin. Assembly should be done in the stages shown in the following diagrams, keeping
Important Safety Information
Please read these instructions carefully before attempting to install this product. It is advisable to keep these instructions in a safe place for further reference. We recommend that you consult
a qualified electrician. All electrical installations must be carried out in accordance with current IEE Wiring regulations (BS 7671). These products must not be modified, if any
modifications are made, it may invalidate the warranty and may render the product unsafe. These LED lights operate at low voltage (12 V). Do not wire the individual LED light fittings directly
into the mains.This product is for indoor use only. Keep out of moisture and use only in dry rooms.
Safety Instructions
1. Before commencing installation or maintenance, isolate the
main electrical supply for the appropriate circuit at the fuse board.
2. This product is only suitable for connecting to a 240 V 50 Hz
supply. The light should be mounted onto a secure surface. Position lights
where they will not be exposed to steam, splashes ect.
3. Never exceed the total output of the LED driver.
4. Suitable for furniture lighting.
5. When the lamp expires the fitting must be replaced.
6. Class III safety extra low voltage ( SELV ).
7. 0.8 W per fitting.
LED DRIVER
The electronic LED driver AED0-1LSVP is
exclusively designed for the Light Emitting Diode
(LED) lamps used in indoors. The electronic
driver is a switch mode power supplier with
12 V DC constant output voltage.
An electronic protection circuit switches off the
electronic driver in case of a short circuit or
overload in the secondary circuit, overheat as well
as open the circuit. This driver is a thermally
protected device; the type of protection is automatic
resetting type. After the removing of the faults, the
electronic LED converter is ready for operation
again.
Waste Electrical and Electronic Equipment (WEEE)
All packaging materials and fittings should be discarded appropriator according to the European directive 2002/9 6/EC on
WEEE. By ensuring this product is disposed correctly, you will be helping prevent potential negative consequences for the
environment and human health.
The Symbol on the product, or on the document accompanying the product, the crossed out wheelie bin symbol, indicates that this
product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of
electrical and electronic waste.
1 x 300 mm LED Flexible light
1 x Adhesive strip
Check the pack and make sure all the componentsare included – if not call the
Important information for the installation
The unit conforms to the directive 2004/108/EC for
the electromagnetic compatibility and the low
voltage directive 73/23/EEC.
1. The electronic driver can only be used with
the LED lamps.
2. The electronic driver is only suitable for
used indoors. Protect the electronic driver
against excessive heat (permissible operating
temperature range -20 to +40ºC.
3. Connect the LED lamps to the electronic LED
driver with correct polarity according to the
above drawing.
Tools required (Not Supplied)
Scissors
If the electronic LED converter is used for purposes
other than originally intended or it is connected in the
wrong way, no liability can be taken over for possible
damages.
FITT-10401
833.02.610
833.02.620
Issue 1
run