Advertisement
Installation Warnings
SAFETY FIRST-
Follow all precautions in the important safety instructions section in this manual. Pay close attention
to the DANGER, WARNING and CAUTION boxes within this manual and labeled on the unit.
WARNING:
ELECTRICAL POTENTIALS HAZARDOUS TO HUMAN LIFE CAN EXIST WITHIN THIS EQUIPMENT
WHEN ENERGIZED. DISCONNECT ALL INPUT POWER BEFORE OPENING CASE OR TOUCHING
INTERNAL PARTS. USE PROPER LOCK-OUT / TAG-OUT PROCEDURES.
THE INFORMATION CONTAINED HEREIN MAY NOT COVER ALL VARIATIONS IN EQUIPMENT OR
PROVIDE FOR ALL CONTINGENCIES WHICH MAY BE MET DURING INSTALLATION, OPERATION
AND MAINTENANCE.
INSPECTION UPON RECEIVING
Transformers should be carefully inspected upon receipt to ensure that no damage has occurred
during shipment. Any damage should be reported at once and a claim placed against the
transportation company.
INSPECTION DURING INSTALLATION
The transformer should be carefully inspected for any damage due to handling after receipt. The
nameplate rating on the unit should be checked against the job specifications to ensure installation of
the correct transformer. The transformer should be connected only as described on the label found
on the inside of the transformer cover or as shown in this manual.
Taps should be adjusted, if necessary, to match the available line voltage. Any bolted electrical
connections, including taps, should be checked and tightened since fasteners may have loosened
during shipment.
Warning- Fire Hazard
Primary and secondary over-current protection and conductor sizing must be in accordance with
ABYC recommendations.
Warning- Fire Hazard
Do not store any equipment on or next to transformer; The ProSafe Isolation Transformer is designed
to operate hot and must have free air flow to prevent over heating or damaging of neighboring
objects.
Warning- Shock Hazard
In-water and on board shock hazard; The ProSafe Isolation Transformer must be connected in
accordance with these installation instructions.
Warning- Electrical Shock and Fire Hazard
The ProSafe isolation transformer is designed for installation inside an engine room or similar
compartment inside the boat. Assure that the location of installation will not be subject to rain, snow,
excessive moisture or excessive heat.
Warning- Installation Precaution Boat wiring should only be done by qualified personnel as it can
cause shock, corrosion and other hazards if not done properly. For more information on this subject
contact the American Boat and Yacht Council (ABYC).
5
Advertisement
