Advertisement
H
& T
INTS
IPS WHEN PROGRAMMING YOUR
The lights (LEDs) on the remote referred to in
•
these instructions are below the i and BACK
buttons. The colour of the LEDs can be
GREEN,
AMBER
When programming the A6 to duplicate another remote's function - lie both remotes
•
on a flat surface, no more than 1cm apart and with the infrared "eyes" facing each
other
When the LEDs blink repeatedly in AMBER, the A6 remote is in "learning mode" (this
•
means it's ready to "learn" a command from another remote). If the A6 is in "learning
mode" and more than 20 seconds go by without interaction, the programming
sequence will time out.
Two
RED
blinks (at any stage) indicate an error. If you see these two
•
while programming the remote, start the sequence from Step 1.
To delete all programming on the remote (and return the A6 remote back to factory
•
defaults) :
1.
Press and hold ARC and STANDBY for three seconds. (LEDs are now solid
AMBER)
2.
While continuing to press down ARC, release the STANDBY button (LEDs
remain sold AMBER)
3.
Press 9949 (The LEDs will blink
followed by three
that the remote has returned to factory defaults (and all programming has
been deleted)
4.
Release the ARC button
And don't forget, if you get a new TV or replace any of the devices that you have
•
used when programming the A6 remote, you will need to delete and reprogramme
the necessary sequences.
DStv Remote A6 (Advanced Options)
or RED.
GREEN
Although the DStv A6 Remote is able to "listen" (or learn") from
other remote controls, we cannot guarantee that it is compatible
with all remotes, across all models of audio/visual equipment.
For queries and support when using the Advanced Options of your
A6 remote, please make use of our interactive forums on
www.dstv.com
where our team will be able to assist you.
A6 R
AMBER
each time you press a button,
blinks when you press the last 9). This confirms
EMOTE
RED
blinks
Page 3 of 10
Advertisement
