Wireless Surround Speaker System; Installation Of The Wireless System Philips Ad902W - Philips 28PW6516/01 Manual

Wireless surround speaker system

The television can be equiped with an optional wireless surround speaker system (reference AD902W).
With this system, the DOLBY PRO LOGIC and HALL SURROUND modes are now availables (see p. 9).
For more informations about this system, contact your dealer.You can also connect active loudspeakers (see p.14).
Installation of the Philips wireless system AD902W
POWER
ON/OFF
CHANNEL
(1 TO 7)
16
All manuals and user guides at all-guides.com
This system includes :
- a wireless RF transmitter to be clicked to the back of
the TV,
- an active loudspeaker, which includes the RF receiver,
the mains supply, a power switch, a connector clip
and a channel selector located on the base,
- a passive loudspeaker to be connected to the active
loudspeaker,
- a speaker cable.
& After switching off the television, connect the RF
transmitter to the connector located on the back of
the set.Then click the module to the back of the TV as
shown opposite.
é Place the 2 loudspeakers at the rear and on either side
of the listener. Connect the active and passive
loudspeakers together with the supplied cable, making
shure the polarity (the + on the + and the - on the -) is
maintained. Connect the active loudspeaker to the
mains (220-240 V / 50 Hz) with the mains cable.
" At the bottom of the active loudspeaker, set the slide
channel to channel 1. Switch on the active speaker with
the power switch.The indicator at the front of the
active speaker lights up red when the speaker is in
standby and green when there is a surround sound
transmission. It turns back to red (standby) when the
tv is switched off or when the rear channel is not used
(in the case of STEREO, DOLBY 3 STEREO and
3D SURROUND modes).
Now proceed to the surround speaker adjustments in the TV
menu (see next page).