Summary of Contents for Solarbayer NANOSOL 135
- Page 1 P R O D U C T I N F O R M AT I O N Solar collector NANOSOL 135 Technical description...
-
Page 2: Safety Regulations
PRODUCT INFORMATION Satellite collector NANOSOL 135 Safety regulations Carefully read the safety instructions before commencing the installation. It’s for your own safety. Please follow the structural instructions if the installation location of the solar system is above 600m sea level or possibly exposed to large amounts of snow (higher than zone 4). -
Page 3: Technical Data
PRODUCT INFORMATION Satellite collector NANOSOL 135 TECHNICAL DATA data unit NANOSOL 135 storage capacity empty weight cold water inlet / hot water outlet 3/4" Anode plug 1"1/4 collector area 0,966 calibration of pressure relief and non return valve maximum working pressure... -
Page 4: General Informations
PRODUCT INFORMATION Satellite collector NANOSOL 135 GENERAL INFORMATIONS 1.1 Use of the appliance 1.2 Description of components This appliance provides users with domestic hot The appliance is a storage solar water heater made water, exploiting solar energy and it can be used in... -
Page 5: Safety Devices
PRODUCT INFORMATION Satellite collector NANOSOL 135 1.3 Safety devices ATTENTION: Pressure relief and non return valve Danger of serious burns! If the The protection from overpressure or overheating appliance is located in a place easily foresees the expulsion of a given mass of water in... -
Page 6: Installation Recommendations
PRODUCT INFORMATION Satellite collector NANOSOL 135 INSTRUCTIONS 2.1 Installation recommendations order to make a possible subsequent installation of more appliances easier and quicker. The total daily measured value of the incident radia • Domestic hot water consumption: On average tion is 26.7 MJ/m at an ambient temperature of about 9 ... - Page 7 PRODUCT INFORMATION Satellite collector NANOSOL 135 Excellent inclination The entry of the pipes into the building has to be resistant against rain and condensation: make sure that the pipes coming out from the building and that will have to be connected to the “cold water inlet hot water outlet”...
- Page 8 PRODUCT INFORMATION Satellite collector NANOSOL 135 Examples of possible positioning: Solar water heater located on a flat roof (or on a bal cony). Solar water heater located in a garden and connected to the domestic hot water system. Solar water heater mounted on a outer wall.
-
Page 9: Magnesium Anode
PRODUCT INFORMATION Satellite collector NANOSOL 135 Fitting of the pressure relief and non return valve 2.6 Installation o the appliance The pressure relief and non return valve supplied with Installation of a single unit the appliance must be fitted to the cold water inlet (the... -
Page 10: How To Use The Appliance
PRODUCT INFORMATION Satellite collector NANOSOL 135 Where water does not suite the above parameters, Breaking of one cupola (of of both) the warranty will decay automatically. • The breaking of one or both cupolas, with the The solar water heater is equipped with a magnesium consequent making of consensation between anode (1) that protects the tank against galvanic cor... - Page 11 Part 3: Performance test methods for solar water heater stores, control unit. Protective diodes limit the damage caused by overload to a DVGW – worksheet GW2 Connecting copper pipes for gas and water minimum. Solarbayer control units are regularly equipped with an overload installations protection.
- Page 12 IHeat pumps www.solarbayer.de This manual and the pictures and drawings within are protected by the copyright of SOLARBAYER GmbH. Technical changes and errors reserved. Valid is the most recent version of this handbook which can always be found on our homepage www.solarbayer.de...
Need help?
Do you have a question about the NANOSOL 135 and is the answer not in the manual?
Questions and answers