GE Profile PFSF6PKX Owner's Manual & Installation Instructions page 28

INSTALLING THE REFRIGERATOR
REMOVE THE REFRIGERATOR DOORS
5
A Open the refrigerator doors.
Remove the two front caps with a flat-head screwdriver.
B
Remove the three screws on top with a Phillips-head
C
screwdriver.
D
Disconnect all electrical connectors.
E To disconnect the water coupling, push in on the gray
coupling and pull out the tubing.
Gray
Coupling
F Remove the two ground wires with a Phillips-head
screwdriver, one on each side.
G Remove three 10 mm hex-head bolts (right and left).
Ground
Wire
CAUTION:
the door may fall and cause personal injury and/or
damage to the door itself.
Installation Instructions
When the bolts are removed,
(cont.)
REMOVE THE REFRIGERATOR DOORS
5
Lift the door straight up to remove.
H
I Remove the two bolts using a 3/16" Allen wrench
and two Phillips-head screws from the center hinge.
Set the hinge, bolts and screw aside.
REPLACING THE REFRIGERATOR DOORS
6
Install the center hinge on each side.
A
Lower the refrigerator door onto the center hinge pin.
B
Ensure that the plastic hinge pin thimble is on the center
hinge pin or inside door hinge pin hole located in the
bottom of the door.
Securely tape the door shut with masking tape
C
or have a second person support the door.
28
(cont.)