Page 1
Speaker Outputs Green/Black Rear Left - Output MRA-470D boasts fully variable high pass and low pass crossovers Green Rear Left + Output enabling it to drive loudspeakers in a variety of configurations. A...
C.) Installation Application carefully routing them, tying them down and using grommets where MRA-470D is designed for operation with 12 volts, negative ground applicable. Secure all wiring as needed using cable ties or wire electrical systems. Using this product in systems with positive clamps to protect them from moving parts.
Page 4
Stock electrical systems which are in good condition should be able within 40cm of the battery positive terminal to handle the extra load of the MRA-470D amplifier without Run the speaker wires to the amplifiers output. Make sure problems, although battery and alternator life can be reduced correct polarity when connecting your speakers to the amplifier.
Page 5
Ground & Remote connections can only be used with the The amplifier’s settings and controls are located on the side panel Celsus BTC10-001 and must not be used with any other product. beneath a gasketed, protective cover. Remove the five Allen head...
In all modes and configurations the input gain (SENS) should be H.) Troubleshooting tested and tuned in accordance with the speakers and audio source used. This requires a multi-meter. GAIN IS NOT VOLUME Problem Cause Solution CONTROL. Speaker are not connected Does not sound Refer to experienced correctly...