1. SAFETY WARNINGS Before using this device, please read this manual carefully and keep it for future use. If you pass this device on to someone else, pass this manual as well. - Appliances can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the...
Page 4
the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard - CAUTION: Make sure the device is turned off before removing the accessory. - The device must not be submerged in water. - Refer to CLEANING AND MAINTENANCE section for cleaning and descaling instructions.
type and amount of fluid to use. - Surfaces are likely to be hot during use. - Do not put heavy weight on power cord. - Do not touch directly the steam. - Do not drain the appliance when it is connected to water mains.
3. YOUR PRODUCT AND ACCESSORIES Name Function Safety cap Maintain pressure balance & Lock the filling hole Filling hole Fill water inside Use for fastening various accessories connection, press Attachment lock it to remove the accessories Steam outlet For steam output Indicator light Red means heating, green means appliance is ready Trigger lock...
Page 7
Funnel ×1 Measuring cup × 1 Towel set ×1 Flat brush x 1 Big nozzle x 1 Extension hose× 1 Nylon brush x 1 Stainless brush x 1 Connect of floor Floor brush x 1 brush X1 Floor brush towel Extension tube x 3...
4. OPERATION 1. Put the steam cleaner on the platform and open the safety cap. 2. Use the measuring cup and funnel to fill the water. Maximum volume is 400ml. We suggest you only fill water 300-350ml to get the dry steam. If more than 350ml water, there may some water in the steam at the first 2 minutes.
After usage, please turn the power off, release all the residual steam and wait for the machine cooling down. The steam cleaner has an overheat protection. It will automatically switch off if it overheats (e.g. when the water tank is empty). 5.
Page 10
4) Nylon and stainless brush Insert the big nozzle into the notch of the round brush (below picture 1), and turn it clockwise until it clicks. After use, take out the round brush by turn it anti-clockwise. To disconnect the nozzle, press the release button on the device and then remove the nozzle. 5) Extension tube If some areas are difficult to access or if the appliance is used to clean the floor or glass surfaces, use the extension cords provided.
7) Steam temperature Below data is for users’ reference, we can adjust the operation method in order to reach better cleaning performance. Attention: The above data are measured by the laboratory, and there will be a little deviation in practice. 6.
7. TROUBLESHOOTING Situation Abnormal analysis Solution Plug not insert to the power socket Reinsert or change socket tightly No spray steam No water in the boiler Add water Not press the steam button Press on children lock Other problem Ask professional service Only green light is on, Indicator light broken or short circuit of Ask professional service...
EC Declaration of conformity BUILDER SAS 32, rue Aristide Bergès - ZI 31270 Cugnaux – France Declares that the machine indicated below: Designation: Steam cleaner Model: FHNVM1200 Serial number: 20210755390-20210756349 Is in conformity with the European Directives: LVD Directive 2014/35/EU EMC Directive 2014/30/EU...
11. WARRANTY WARRANTY The manufacturer guarantees the product against defects in material and workmanship for a period of 2 years from the date of the original purchase. The warranty only applies if the product is for household use. The warranty does not cover breakdowns due to normal wear and tear. The manufacturer agrees to replace parts identifed as defective by the designated distributor.
12. PRODUCT FAILURE WHAT TO DO IF MY MACHINE BREAKS DOWN? If you bought your product in a store: a) Empty the fuel tank if your product has one. b) Make sure that your machine is complete with all accessories supplied, and clean! If this is not the case, the repairer will refuse the machine.
13. WARRANTY EXCLUSIONS THE WARRANTY DOES NOT COVER: • Start-up and setting up of the product. • Damage resulting from normal wear and tear of the product. • Damage resulting from improper use of the product. • Damage resulting from assembly or start-up not in accordance with the user manual. •...
Need help?
Do you have a question about the FHNVM1200 and is the answer not in the manual?
Questions and answers