Bison VB76 Instruction Manual

—— Instruction Manual ——
Freestanding Folding Officials Platform
The factory installed safety pin must be fully inserted and secured with the retaining wire prior
•
to use. Check this connection each time the judges stand is used, failure to use the safety pin
Make are all safety padding is in place prior to play to reduce the chance of injuries.
•
 Inspect all contents prior to installation. Report any missing parts to dealer immediately.

Read all instructions before proceeding.
Item Qty Description
A 1 Front Frame
B 1 Ladder Frame
C 1 Platform
D 2 Wheels
E 2 5/16" x 3" Hex Bolt
F 2 5/16" Jam Nut
G 2 5/16" Lock Nut
1. Use the 3/8" X 1 1/2" Hex Bolts (H), Plastic Washers (K) and 3/8" Lock Nuts (J) to attach
Ladder Frame (B) to Front Frame (A) making sure Plastic Washer (K) is positioned between
Ladder Frame (B) and Front Frame (A). See Page 2, Figure 1.
2. Use the 3/8" X 1" Hex Bolts (I) and 3/8" Lock Nuts (J) to install Platform (C) to the Front Frame
(A). See Page 2, Figure 1.
3. Use the 5/16" X 3" Hex Bolts (E), 5/16" Jam Nuts (F) and 5/16" Lock Nuts (G) to attach Wheels
(D) to Ladder Frame (B). See Page 1, Figure 1.
4. Install VB75P Padding Set (L) by removing the vinyl wrap, install foam tubes around the judges
stand and replacing vinyl wrap around the foam tubes using the sewn in Velcro to secure
padding in place. See Page 2, Figure 2.
5. Install 12" Slip Resistant Stair Tread Tape (M), centered on each step on the ladder frame.
See Page 2, Figure 1.
Date: 12/14/2017 Rev: 4
VB76
could cause judges platform to collapse causing serious injury.
Maximum allowable load is 250 pounds
•
B.A. N.J.C.
Warning!
P A R T S L I S T
Item Qty Description
H 2 3/8" x 1 1/2" Hex Bolt
I 2 3/8" x 1" Hex Bolt
J 4 3/8" Lock Nut
K 2 Plastic Washer
L Set VB75P Padding
M 3 12" Slip Resistant Stair Tread Tape
File: \ I:\Publisher\Instructions\volleyball
1
Customer Service
(800) 247-7668
Ref#: 960550