Page 4
• GROHE recommends not leaving the filter system out of • The boiling water storage heater must be connected to service for extended periods of time. If the filter system is a permanent power supply with earth wire.
Page 5
The sensor (J) must be installed horizontally. address: Install display unit (G), see Fig. [15]. GROHE Deutschland Vertriebs GmbH Use suitable screw and if applicable wall plug or secure using Zur Porta 9 double-sided adhesive tape (not included in the scope of D-32457 Porta Westfalica delivery).
Page 6
- Press and hold button (S) on storage heater for at least 2 seconds to switch on the storage heater. The red indicator lamp (S1) indicates that the storage heater is switched on. 4. Open the GROHE Red boiling water fitting and flush with one storage heater fill (4 litres).
Page 7
Hotline under TechnicalSupport-HQ@grohe.com. Inspect and clean all parts, replace as necessary and lubricate with special grease. The GROHE Red boiling water storage heater cannot be repaired. If servicing is required, the complete storage heater must be replaced. Filter (H), see fold-out page III, Fig. [21].
Page 8
Storage valve losing • Hose connection or internal tank leaking - Switch off the storage heater, disconnect the mains water plug and contact GROHE Customer Service Splashy, irregular • Fitting mousseur dirty or defective - Replace mousseur, see section Maintenance...
Need help?
Do you have a question about the Red Mono 30 060 and is the answer not in the manual?
Questions and answers