Thermaco Big Dipper 40000 Series Quick Start Manual

Advertisement

Quick Links

40000 Series Big Dipper®
Technical Support Instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Big Dipper 40000 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Thermaco Big Dipper 40000 Series

  • Page 1 40000 Series Big Dipper® Technical Support Instructions...
  • Page 2 Connection Connection (page 3) Heater Connection Neutral (to Power Thermistor Supply Cord) Connections Board Power (115V) Board Power (220-240 V) Ribbon Cable (to Push Button Interface) 2 • info@thermaco.com • www.big-dipper.com • 1-800-633-4204 Copyright 2014 • Big Dipper® Thermaco, Inc®...
  • Page 3 Thermistor control until skim cycle is complete. No Heater Operation To deactivate heater, move jumper to Position A. In situations with low water turnover or grease production, a heater may not be necessary. Contact a Thermaco representative before deciding to deactivate heater operation. AST Settings The AST Settings only affect operation of the unit when the AST Solenoid is wired to the board.
  • Page 4 **Access Extreme Mode by interrupting power from unit (disengage safety switch or unplug from electrical socket) and then holding down Heavy (III) Button while resuming power supply to unit. To return to Default Mode, interrupt power and hold down Light (I) Button while supplying power. 4 • info@thermaco.com • www.big-dipper.com • 1-800-633-4204 Copyright 2014 • Big Dipper® Thermaco, Inc®...
  • Page 5 Dipper units shipped with Supplemental Water Supplies for use with Rotisseries or Combi-Ovens. HEATER: Jumper on Position B for Silmutaneous Heat AST: N/A MODE (Skim Operation): Jumper on ROT for Rotisserie/Thermistor Operation info@thermaco.com • www.big-dipper.com • 1-800-633-4204 Copyright 2014 • Big Dipper® Thermaco, Inc®. • 5...
  • Page 6 WRITTEN CONSENT FROM THERMACO, INC. POSSESSION OF THIS DRAWING DOES NOT CONSTITUTE THE RIGHT TO MA OF THIS DRAWING DOES CONSTITUTE AN IMPLIED AGREEMENT BETWEEN THERMACO, INC. AND THE HOLDER OF THIS D In Error Code events, all four lights on the Push Button Interface will flash in one of the following DESTROY THIS DRAWING, IT IS THE SOLE PROPERTY OF THERMACO, INC.

Table of Contents