1. Manuals
  2. Brands
  3. Sparr Manuals
  4. Adapter
  5. EAD01-102
  6. Quick start manual

Sparr EAD01-102 Quick Start Manual

Hide thumbs
1
2
3
4
5
6

Advertisement

Table of Contents

EAD01-102
QUICK START CONTENTS
1)
PACKED BOX CONTAINS ...................................................2
2)
PIN OUTS.......................................................................... 3-4
3)
LED INDICATIONS. ............................................................. 5
4)
QUICK TEST.......................................................................6-7
WWW.sparrl.com
EAD01-102 QUICK START
1
QUICK START

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EAD01-102 and is the answer not in the manual?

Questions and answers

Related Manuals for Sparr EAD01-102

Summary of Contents for Sparr EAD01-102

  • Page 1 QUICK START EAD01-102 QUICK START EAD01-102 QUICK START CONTENTS PACKED BOX CONTAINS ……………………………………………2 PIN OUTS.………………………………………………………………. 3-4 LED INDICATIONS. ……………………………………………………. 5 QUICK TEST.…………………………………………………………….6-7 WWW.sparrl.com...

  • Page 2: Packed Box Contains

    EAD01-102B 2) PIN OUTS This is the board level unit of EAD01-102.It contains a serial interface (RS-232) and a network interface (RJ45). On the board there will be berg pins as shown (JP3 for RS-232 and JP5 for RS-485). We can make the serial connection and give the power through these pins.
  • Page 3 QUICK START Berg pin Female with wire The male connector (RS-232) is shown below. WWW.sparrl.com...

  • Page 4: Led Indications

    QUICK START 3) LED INDICATIONS. There are six LEDs on the board. Power (D2), Connection (D31), RXD (D3), TXD (D32) and two other LEDs in the RJ-45 connector. LED state Function D2 LED glowing Power On D31 LED glowing Connection Status Both D2 and D31 EAD is ready to use.

  • Page 5: Quick Test

    QUICK START 5) QUICK TEST: For a quick test you can follow the steps below. Power on the unit. Check whether the LED indications are correct or not. iii) Press and hold the switch on the board for 10 seconds to load the default configuration settings.
  • Page 6 QUICK START vii) You can set the IP Address to 192.168.0.xxx. For further configuration please refer the Manual of EAD01-102. viii) Remove the LAN cable and restart the unit. Open the Hyper terminal with the settings as Connect using COM1, Baud rate ”9600”, Data bits ’8’,Parity “None”...

Table of Contents