Gecko AIR.WAV-DTH 120-P-H600-GE1 User Instructions & Installation

AIR.WAV-DTH
UserInstructions&Installation
Manufacturer warranty applies only if proper installation was performed.
On/Offkey
The On/Off key is used to turn the blower on or off.
When the blower is started, it will run for 20 minutes.
The indicator light in the upper right corner of the key
will be on to indicate that the blower is running.
Wavekey
Pressing the Wave key while the blower is running makes
the blower speed gradually change from the minimum to a
user-defined maximum. The "On/Off" indicator light's inten-
sity changes smoothly to indicate wave mode. Pressing the
Wave key a second time will turn the blower back to
normal mode, at constant speed.
Pulsekey
Pressing the Pulse key while the blower is running makes
the blower speed rapidly change from the minimum to a
user-defined maximum. The "On/Off" indicator light will
flash to indicate pulse mode. Pressing the Pulse key a
second time will turn the blower back to normal mode,
at constant speed.
+and-keys
In normal mode (in which the blower speed is constant),
these keys allow the user to change the blower's speed.
In wave or pulse mode, these keys allow the user to set
the maximum blower's speed.
Automaticpurge
Fifteen minutes after the system has shut off, the blower will
start up again for a one-minute purge cycle allowing the
system piping to dry. The indicator light will flash during
the 15-minute pause.
Programmabledailypurge
It is possible to program a 1-minute purge that will be
repeated every day at the same time. To enable the daily
purge, press and hold the + key for 5 seconds. The "On/
Off" indicator light will flash twice as a confirmation.
To disable the programmable daily purge, press and hold
the + key for 5 seconds again.
120-P-H600-GE1
To be read prior to installation!
QuickReferenceCard