Related Manuals for Aerus Beyond LAUNDRY PRO 2.0
Summary of Contents for Aerus Beyond LAUNDRY PRO 2.0
- Page 1 COLD WATER LAUNDRY SYSTEM (EURO) READ MANUAL CAREFULLY FOR PROPER USE AND OPERATION. Made in the USA 2017 Space Technology Hall of Fame Inductee...
-
Page 2: Table Of Contents
Laundry Pro 2.0 is easy to install. It is intended to work with residential clothes washers and is for use by anyone interested in an economical, earth-friendly Aerus Distributor ______________________________________________________ alternative to the typical detergents and chemicals currently available, _____________________________________________________________________ without modifying existing appliances, electrical systems, or plumbing. -
Page 3: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS Read this manual in its entirety prior to installing or using your Laundry Pro 2.0. We have provided important safety • For indoor use only warnings in this manual • Do not operate unit with cover removed and on your appliance. -
Page 4: Installation Requirements
INSTALLATION REQUIREMENTS ELECTRICAL REQUIREMENTS LOCATION CONSIDERATIONS 100 - 240 Volt 50/60 Hz 5 AMP (minimum) Fuse or Circuit Breaker. The Laundry Pro 2.0 must never be installed in areas where water Laundry Pro 2.0 is equipped with an AC to DC power supply. may freeze since the unit will always maintain some water in the unit, the water valve, and hose areas. -
Page 5: Before You Start
BEFORE YOU START NOTE: Your Laundry Pro 2.0 unit was factory tested. It is normal for some residual water to still remain in the unit as a result of these tests. • Remove your new Laundry Pro 2.0 from its packaging •... -
Page 6: Installation Of Wall Anchors Or Screws
INSTALLATION OF WALL ANCHORS OR SCREWS 1. Place the Laundry Pro 2.0 to the wall and mark the appropriate keyholes with a pencil. 17.3” (43.94 cm) NOTE: Washing machine and cold water faucet must be within 4 feet (1.21 m) of the right side of unit. A. -
Page 7: Reinstall The Cover
REINSTALL THE COVER 1. Return the Laundry Pro 2.0 cover to its original position, fitting the bottom in place and tipping upward. 2. Secure with two (2) screws (not shown) along the top edge. Screws 3. Put the two (2) remaining screws along the bottom edge and tighten. NOTE: Remove the two black caps from the hose connections before installing hoses. -
Page 8: Connecting The Power Adapter
CONNECTING POWER ADAPTER Do not use any AC/DC adapter other than the one supplied with your Laundry Pro 2.0 or Aerus replacement AC/DC adapter (item#: 49874-EURO/49873-US). Failure to follow these instructions may void your warranty and/or result in damage to your CAUTION: unit, fire, or electrical shock. -
Page 9: System Set Up
SYSTEM SET UP WARNING: WARNING: Electrical Shock Hazard. When working with electrical connections, the appliance Electrical Shock Hazard. Do no use an extension cord. and surrounding area should be clean and dry of any standing water. Failure to Failure to follow these instructions can result in death, follow these instructions can result in death, fire, or electrical shock. -
Page 10: Changing The Activepure® Cell Assembly
CHANGING THE ACTIVEPURE CELL ASSEMBLY (S/N 49883) NOTE: The ActivePure Cell Assembly requires replacement at approx. 9,000 hours of use. The LED will flash periodically (visual chirp) to notify that cell replacement is required. The UV bulb will NOT be turned on again until the cell has been replaced. Figure 1 1. -
Page 11: Before Washing Clothes
BEFORE WASHING CLOTHES BEFORE USING YOUR LAUNDRY PRO 2.0 FOR THE FIRST TIME CAUTION: To avoid the possibility of water damage, should a IF YOUR WASHING MACHINE IS NEW, skip this section and continue hose leak, always have faucets accessible and turn off below. -
Page 12: Washers Requiring Hot & Cold Water
FOR WASHERS THAT REQUIRE HOT & COLD WATER INPUT Some washing machine models require water pressure to both the Hot and Cold valves for proper operation. In some cases, if only the COLD water side is connected, the water valve will not operate CAUTION: or the washing machine will not fill to the proper level. -
Page 13: Temp. Control & External Water Tap
TEMPERATURE CONTROLLING WATER VALVES Some washers monitor the incoming cold water temperature and adjust too cold of water by adding hot water, even if the water temperature is set to cold. If you have one of these washers, do not install with the “Y” adapter as it may cause the washer to not operate correctly. Consult your washing machine owner’s manual if needed. -
Page 14: Frequently Asked Questions
If the cold water valve is stuck or the washing machine needs to be moved back which may require re-leveling, a plumber may be required. Aerus is not liable for improper installation or damage caused from improper installation and recommends a licensed plumber. -
Page 15: Troubleshooting
TROUBLESHOOTING LAUNDRY TOPICS: Illumination State Condition Solution Blue Steady on Normal operation Unit is operating normally. Blue 2 Flashes (flash, flash - UV bulb start up failure Press and hold the reset button for a couple seconds. When the blue LED flashes 3 2 sec pause, flash, flash times (long flashes), run the unit to verify it’s working. - Page 16 TROUBLESHOOTING (CONTINUED) The Laundry Pro 2.0 System does not release into the water any type of harmful chemicals or agents that will harm clothes, the washer, or the environment. The tables below are answers to common laundry questions compiled by the washing machine manufacturers. Issue Common Cause Solution...
-
Page 17: Warranty Information
CONSEQUENTIAL DAMAGES products are returned to your distributor within the following time periods: Aerus SHALL NOT IN ANY CASE BE LIABLE FOR SPECIAL, INCIDENTAL OR • Laundry Pro 2.0 within 2 years of date of purchase. - Page 19 Consult the Independent Contractor for help. For information regarding the use of this product please call Customer Service. 1-800-572-0502 www.beyondbyaerus.com España: www.laundrypro.es Italia: www.laundrypro.it Portugal: www.laundrypro.pt Aerus LLC 300 East Valley Drive | Bristol, VA 24201 | 800.572.0502 © Aerus LLC. All Rights Reserved...
Need help?
Do you have a question about the Beyond LAUNDRY PRO 2.0 and is the answer not in the manual?
Questions and answers