MA 96999 Instruction Manual page 8

Cod. 96999
Caution!
Please use the supplied net adaptor only, or another one with the same technical data,
otherwise the device may become damaged. In order to achieve the maximal charging
capacity of the battery, before the first use charge the device fully. The first charging cycle
takes 12 hours.
During the actions described above, you should disconnect the power plug from the socket
after charging the battery for 12 hours, in order not to overload it.
Starting operation with the ON/OFF button
1. Before each use you should empty the collection container and clean it.
2. To switch the device on, move the ON/OFF switch forwards.
The device begins operation.
3. In order to switch the device off, move the ON/OFF switch backwards.
The device switches off.
Cleaning the filter
1. The collection container should be emptied and cleaned after each use.
2. To clean the collection container, Hold the vacuum cleaner in a vertical position, with the
intake mouth pointing down.
3. Press the unlocking button and pull the dust container gently out.
4. Empty the container If you like, you may wash it with soap and water and then dry it.
5. Refit the filter into the dust container.
6. If damaged, replace it with a new one.
7. Then refit the collection container and place the cleaner on the wall holder.
8. Wipe the outside of the cleaner with a dry cloth. DO not clean the unit with paint thinner
or chemical solution and this will damage the unit.
Dust container (Dirt/Liquid) Removal:
l. Dirt and liquid in the collection container should be emptied after each use.
2. Hold vacuum cleaner vertically with the air-intake (nozzle end)pointing downward to avoid
spillage.
3. Press the unlocking button in top of the vacuum cleaner and release the collection container.
4. Remove the Filter Bracket from the collection container.
5. Empty, wash ,wipes and dries the interior of the collection container.
Caution!
Clean the filter and the collection container with clear water, do not use soap or other cleaning
agents. It would damage the filter. If the filter or the collection container is damaged, you have to
replace it immediately. You can obtain spare parts through Customer Service.
After you have emptied, cleaned and dried the collection container, you can reinsert
the filter and the collection container. Proceed in the reverse order:
Reinsert the filter into the collection container.
⚫
Place the collection container on the motor unit again by inserting it first into the
⚫
opening at the bottom, and then close it. Keep pressing the unlocking device until
the collection container is locked in place.
Cleaning and Maintenance
To clean the casing, switch the device off and disconnect the net adaptor from the socket.
Danger!
Do not expose the vacuum cleaner to extreme weather conditions (rain). Parts of the device
must not be cleaned in the dishwasher.
If necessary, you can clean the casing, dust compartment and filter compartments of the
8