CONTENTS Important Safety Instructions ............. 4 Troubleshooting ................15 Features ....................8 Warranty .................... 16 Getting Started ................... 9 Controls ..................... 11 How To Use ..................12 Remote Control ................. 13 Cleaning .................... 14 English...
See www.vornado.com/circulators- and keep it away from children. If you think batteries might have...
Page 5
Prior to cleaning, turn off the power on your product and unplug. Do Contact Vornado Consumer Service at 1-800-234-0604 (phone) or not use gasoline, thinners, solvents, ammonias or other chemicals consumerservice@vornado.com (email) for further instructions about...
Page 6
- Increase the separation between the product and the receiver. - Connect the product into an outlet on a circuit different from that to which the receiver is connected. - Contact Vornado Consumer Service or dealer or an experienced radio/TV technician for help. Fig. A Fig.
Page 7
Supplier's FCC Declaration of Conformity Unique Identifier: Vornado Models NGT335, NGT425 Responsible Party: Vornado Air LLC Mailing Address : 415 E. 13th St., Andover, KS 67002 Contact: www.vornado.com WARNING: Batteries may pose a choking hazard.
GETTING STARTED BASE ASSEMBLY 1. Place tower circulator horizontally on a table with soft cloth 2. Insert one leg into any of four recesses underneath the tower. Push underneath to avoid scratches. Allow base to extend over edge leg until it locks into place. of table.
Page 10
3. Next to previously installed leg, partially insert another leg into a 4. Base assembly is complete. Position tower circulator upright to recess on the base. Just before locking into place, connect both begin use. legs. Repeat for remaining legs. Note: You may need to flex the legs to get the last of the legs to interlock.
HOW TO USE Before use, check appliance for visible damage. DO NOT USE THIS TOWER if there is evidence of damage. If any damage is found, contact Vornado Air LLC at 1-800-234-0604. 1. Touch to power on. Indicator Lights will turn white, indicating you have left timer adjustment mode.
2. To replace battery, open battery door on tower. Position the tower so the receiver lens ADJUSTMENT -/+ the back side of the remote control (you (inside the Vornado “V” logo) is visible from TIMER will need to loosen the small screw on the remote control.
AIR INLET GRILLE REMOVAL If service is required, return your tower to Screwdriver required. Vornado (see WARRANTY for instructions). You may remove the Air Inlet Grille to WARNING: To reduce the risk of vacuum any dust off the fan blade by...
GFCI has tripped. when the user is changing speeds on a Vornado circulator. In this event, change to an outlet that is not connected to a GFCI device. It could also indicate a weak or defective GFCI outlet. Contact a qualified electrician to check the GFCI outlet.
Vornado, at its discretion, will repair or replace the Product at no cost. parts is not recommended and any consequences will not be covered by support services or product warranties.
Need help?
Do you have a question about the NGT335 and is the answer not in the manual?
Questions and answers