Advertisement
Riverside
email: info@riverside-furniture.com
ASSEMBLY STEPS :
To prevent possible damage to furniture and personal injury, it is recommended that two people are used
to perform the following steps.
3. Carefully position one end of one Bed Rail (R-A) onto the All-thread Bolts installed on the Headboard
and connect using the Curved Washers (R-B) and Nuts (R-C). Only partially tighten the Nuts until the
Footboard has been connected. Repeat for other Bed Rail.
4. Position and connect the Footboard (F-A) to the other end of the Bed Rails, attaching as in the previous
Steps.
5. Carefully align the Footboard to be 'square' with the Headboard. Using the Open Wrench (R-D)
tighten all Hex Nuts attaching the Side Rails to the Headboard and Footboard. (See Detail E).
6. Attach the four Support Legs (F-C) to the bottom side of four Wood Slats (F-B). (See Detail F).
7. Using the Platform Panels (F-D) as a guide, position the Slats where the edges of the panels will be
supported, attach the Slats to the Bed Rails using the Wood Screws (F-E) and your Phillips
Screwdriver (See Detail G).
8. Position and attach the Platform Panels to the Bed Rails using the Wood Screws (F-E) and your
Phillips Screwdriver (See Detail H).
The levelers located at the bottom of the Support Legs can be adjusted if necessary to help support the
Slats.
F-E
Detail: G
F-B
4 pcs.
Detail: F
Queen Storage Bed
Assembly Instructions
FURNITURE
Headboard
Bed rail
R-A
F-C
8 pcs.
leveling
Made in Viet Nam
Verona
R-B
R-D
Bed rail
R-A
Footboard
F-A
Page 2 of 3
R-C
Detail: E
Advertisement
