FCC 05-MAN2321-01-WS Quick Start Manual

BOM #: 05-MAN-2321-01-WS
ADVENTURE FORCE HOT ROD RACER
IMPORTANT
READ THIS MANUAL before attempting to operate the device.
SAVE THIS MANUAL. This manual contains important operating instructions for this device.
PARTS DETAIL
RACER
OFF/ON/MUTE Switch
REMOTE CONTROLLER
Forward/Backward
Smoke
Release
INSTRUCTIONS
1. Turn the Switch on Racer to ON position, and turn the Switch on Remote Controller to ON position. Then the Racer is ready to go.
2. If you do not want any sound effect during play, turn the Switch on Racer to
3. Please use the Gas Tank that comes with this set to add Water to the Racer. Please only add around 6 drops in an empty water container.
DO NOT over fill the water container.
4. Only use this product with clean, room temperature water.
5. Do not use salt water or soapy water.
6. After playing, remove the water cover and put the Racer upside-down to remove any remaining water.
7. For better Battery life, turn the Switch on Racer to OFF position, and turn the Switch on Remote Controller to OFF position after play.
BATTERIES SHOULD BE REPLACED UPON PURCHASE FOR OPTIMAL PERFORMANCE.
DO NOT MIX OLD AND NEW BATTERIES.
DO NOT MIX ALKALINE, STANDARD (CARBON-ZINC) OR RECHARGEABLE BATTERIES.
REMOVE BATTERIES FROM INFREQUENTLY USED DEVICE BETWEEN USES.
Size: 210x297 mm
Remove this cover
to fill in Water
Smoke Release
Left/Right
Battery Instruction
position to play in Mute mode.
Date: 2021-MAR-4
Battery Instruction
ON/OFF
Switch