TransLite Veinlite R Quick Start Manual

R
Veinlite
Battery Cover [D]
Large Tail Holder [G]
Small Tail Holder [H]
READ INSTRUCTIONS BEFORE USE
TransLite LLC
345 Commerce Green Blvd
Sugar Land TX 77478 USA
+1 281 240 3111
www.veinlite.com
info@veinlite.com
Caution
Veinlite R is designed for external use only.
To avoid contamination of the device, Veinlite R must
be used with the disposable plastic cover.
To avoid cross contamination, always change the
disposable plastic cover between subjects and wipe
the new cover with a recommended germicidal wipe.
Always turn the LEDs on after the device is in
position. Do not look directly at the LEDs when they
are illuminated or shine the light from them directly
into anyone's eyes.
Do not immerse the device in liquid.
Do not autoclave the device.

Introduction

The Veinlite R is a hand-held battery powered
transillumination device for visualizing veins and
arteries in the tails of rats and mice.

Applications

To assist in venous and arterial access in rats and
mice tails.
LED Window [A]
End Button [B]
Side Button [C]
Cap [E]
Cover [F]

Operating Directions

Disposable Covers:

The Veinlite R should always be used with a
single-use disposable plastic cover to protect it from
contamination and to prevent the spread of
infection.
1 Place the Veinlite R inside
the disposable plastic cover.
Check the cover to make sure it
is intact and the flap is on the
side away from the LED
Window [A].
2 These covers are not sterile.
They should be wiped
with a germicidal wipe
prior to use.
3 Discard the single-use
disposable plastic cover after each
subject.
Disposable plastic covers are not included and
must be ordered fromTransLite or any of its
authorized dealers.

Device:

1 Install a new Cover [F].
2 Slide Large Tail Holder [G] or Small Tail
Holder [H] over the LED Window [A] to
allow illumination of tail veins.
3 Place Veinlite R against the
tail with the Tail Holder in
contact with the tail.
4 Depress the End Button [B] to
turn on the LED.
5 Apply gentle pressure to the Veinlite R to
maintain optimal contact.
6 Device will turn off after cycling
through the colors or you can
depress and hold the End Button [B] for one
second to turn device off.
7 When you turn on a device with a low battery the
device will shut itself off.
8 Device will shut off after approximately 4 minutes.

Brightness Control:

There are 3 brightness levels. Depress the
Side Button [C] to change the brightness. Each
depression of the button will cycle through low,
medium, and high brightness levels. The lowest
brightness level is the default setting.