Download Print this page

FED BGM-II Manual page 10

Hide thumbs Also See for BGM-II:

Advertisement

Enter setting of unit conversion after setting of minute (as shown in the
following figure); press left or right key to choose the required unit (mg/dL or
mmol/L), then press on/off key to confirm and the screen displays "OK"; the
setting is successfully finished and the tester is automatically shut down.
2.2 Alarm setting:
2.2.1 Turning-on of alarm:
When the alarm mode is "OFF", press and hold on/off key and there will
be time flickering at the bottom of the screen including hour and minute where
you can set the time required to remind you, and the setting method is the
same with that of year setting. After proper setting, "OFF" flickers on the screen;
press left key or right key and the screen will display "On" (flicker) and " " (as
shown below: the alarm time is set as: 12:00 a.m. ); press on/off key again and
the screen display "OK"; the setting is successfully finished and the tester is
automatically shut down;
When the alarm mode is "On", press and hold on/off key and there will be
time flickering at the bottom of the screen including hour and minute where you
can set the time required to remind you, and the setting method is the same
with that of year setting. After proper setting, press on/off key again and the
screen display "OK"; the setting is successfully finished and the tester is
automatically shut down;
2.2.2 Turning-off of alarm:
When the alarm reminds you, press the on/off key once and the screen
displays date and time' press the on/off key again and the Blood
Glucometer will be shut down.
When it is required to cancel the alarm, press and hold the on/off key under
shutdown state of the tester and there will be time flickering at the bottom of
the screen; then press the on/off key twice in a row, "On" will be displayed on
the screen and flickers; press left key or right key, "OFF" will be displayed on
the screen and flickers; then press the on/off button once again and the screen
displays "OK"; the setting is successfully finished and the tester is
automatically shut down.
2.3 Use of test piece code
All manuals and user guides at all-guides.com
10

Advertisement

loading