Summary of Contents for brewer 101381
- Page 1 101381 H-Cable Replacement For Brewer Assist High-Low Table Description H-Cable Cable Ties Document #101382 Rev A 7.8.1...
- Page 2 101381 H-Cable Replacement For Brewer Assist High-Low Table Tools Required: 1/8” Allen Wrench 3/8” Nut Driver or Socket & Ratchet 5/16” Nut Driver or Socket & Ratchet 1/8” Flat Blade Screwdriver 3/8” Flat Blade Screwdriver #1 Philips Screwdriver Wire Cutters or Side Cutters...
- Page 3 101381 H-Cable Replacement For Brewer Assist High-Low Table Remove box shroud This Area Left Blank Document #101382 Rev A 7.8.3...
- Page 4 101381 H-Cable Replacement For Brewer Assist High-Low Table H-Cable Removal and Replacement: Push both side drawers through to provide access to cable rail. Cable Rail Disconnect power cord from electrical plate Disconnect foot control cord from electrical plate. (turn locking ring counterclockwise until loose and pull connector straight out) Remove the four electrical plate corner screws.
- Page 5 101381 H-Cable Replacement For Brewer Assist High-Low Table Cut and remove the (6) six cable ties along the cable rail. Use caution to not cut into cables or wires. Pull electrical plate out enough to access backside. Cut cable tie at outlet box opening. Use caution to not cut into cables or wires.
- Page 6 101381 H-Cable Replacement For Brewer Assist High-Low Table Slide H-Cable down through slot in plate. Use cau- tion to prevent damage to fragile wires. Remove power cord connectors from backside of ap- pliance inlet. Use needle nose pliers. Ground (Green)
- Page 7 101381 H-Cable Replacement For Brewer Assist High-Low Table Pull power cord from opening in outlet box. Pull H-Cable from opening in outlet box. Pull H-Cable from under drawer slides. Pull H-Cable through grommeted hole in rear of cabinet. Place a mark by the (2) H-Cable clamps for later identification and remove clamps.
- Page 8 101381 H-Cable Replacement For Brewer Assist High-Low Table Cut tie wrap carefully. Disconnect the (4) Molex connectors. Remove Control Box locking clip. Remove the (2) H-Cable plug in connections from the Control Box. Installation of the new H-Cable is the reverse of steps 1 through 23.
- Page 9 101381 H-Cable Replacement For Brewer Assist High-Low Table Run the table through all functions to ensure proper operation WARNING Before proceeding with the next step, turn power off at on/off switch at back of rear cabinet and disconnect plug from the electrical outlet! Replace box shroud.