Advertisement
7. STORAGE
7.1.
FOLDING UP THE ENGINE STAND
7.1.1.
Remove 'R' Clips and Flat Washers from the three Locking Pins and set aside for re-use.
7.1.2.
First remove the Locking Pins securing the Engine Stand Post (fig.1.G) to the Centre Beam (fig.1.A).
7.1.3.
Carefully hold the Engine Stand Post/Mounting Plate steady with one hand to prevent it from falling forward while pulling out the Lock
Pin at the Support (fig.1.K) and Engine Stand Post (fig.1.G).
7.1.4.
Rotate the Support (fig.1.K) forward and down over the Centre Beam (fig.1.A).
7.1.5.
Carefully rotate the Engine Stand Post (fig.1.G) forward and down with the Mounting Plate resting atop the Centre Beam (fig.1.A).
7.1.6.
Reinstall the Locking Pins, Washers and 'R' Clips in the open holes to avoid loss.
8. MAINTENANCE
Keep all moving components of the Engine Stand well lubricated and free of any dirt or debris accumulations.
9
The Engine Stand is finished in rugged powder coating which will provide many years of effort-free beauty, however it is advisable to
9
keep the finish clean and free from excessive dust and dirt.
Keep the Engine Stand in a clean and dry environment. DO NOT store it in or expose it to a damp or wet environment.
9
Before each use, inspect all components for potential damage and proper alignment. Check all hardware for tightness
9
DO NOT use if damage is discovered.
8
Occasionally add a heavy-bodied chassis grease to the grease points located on the main pivot shaft and gearbox.
9
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
ES480D Issue:1 29/03/21
Advertisement
