Using The Vacuum Sealer - Dometic VacuSealer VS1000 Operating Manual

Using the vacuum sealer

7 Using the vacuum sealer
7.1 Connecting the vacuum sealer
➤ Plug in the 230 V connection cable (fig. 1 2, page 3) into the socket for
the 230 Vw supply (fig. 4 1, page 4) and connect it to the 230 Vw
mains.
Or
➤ Plug in the 12 V connection cable (fig. 1 3, page 3) into the socket for
the 12 Vg supply (fig. 4 2, page 4) and connect it to the cigarette lighter
or a 12 V socket in the vehicle.
➤ Make sure that the ignition is switched on before you use the vacuum
sealer.
7.2 Making the bags
I
NOTE
 Make sure that the bag is at least 5 cm longer than the food
item. Add another 2 cm in case the bag needs to be sealed
again after cutting.
 The bags must be used in the supplied width, otherwise faults
may occur when sealing.
➤ Roll out the foil from the vacuum roll bag to the required length.
➤ Cut off the foil straight using the cutter. Do not use scissors, or similar, to
do this (fig. 5, page 4).
➤ Lift up the lid (fig. 2 3, page 3).
➤ Place one of the open sides of the foil on the dotted line (fig. 6, page 4).
➤ Press down the sides of the lid with both hands until they click into place
(fig. 7, page 4).
✓ The status display (fig. 2 2, page 3) lights up orange and shows that it
has locked properly.
I
NOTE
If the lid is not closed properly, the status display continues to light
up green. Press the lid down more firmly.
12
VacuSealer VS1000
EN