Advertisement
Quick Links
(C)
(e)
(A)
(B)
ASSeMBLY GUIDe
"pottsville" Corner Fence
• Heavy duty hammer
• Level
• Flathead screwdriver or pliers
• Screwdriver/Square bit #1
(Power screwdriver/Square bit #1
recommended)
• Small block of wood
Part
(A)
(B)
(C)
(D)
(E)
(F)
(D)
(C)
(F)
CNRF1 [10.11.12]
tOOLS
COMpONeNtS
Description
Side sections
48" Center post
39" End posts
Post caps
Metal ground stake (no dig)
Stainless steel screws
Square bit #1
(A)
Qty
2
1
2
3
3
12
1
Advertisement
Related Manuals for highwood Pottsville
Summary of Contents for highwood Pottsville
- Page 1 ASSeMBLY GUIDe “pottsville” Corner Fence CNRF1 [10.11.12] tOOLS • Heavy duty hammer • Level • Flathead screwdriver or pliers • Screwdriver/Square bit #1 (Power screwdriver/Square bit #1 recommended) • Small block of wood COMpONeNtS Part Description Side sections 48" Center post 39"...
- Page 2 Before you start IMPORTANT Check for underground services with your local authorities BEFORE installation of this product. They will typically mark out underground cables/gas etc at no charge. Step 1 Step 3 Set the fence in the desired location and carefully measure and Set ground stake tabs into place mark the ground where the center of each post will fall assuring that each rail will set at a 45 degree angle as shown below.
- Page 3 Note: Make sure to slide the post straight down so the locking following Steps 2, 3, and 4. tabs touch the inside wall and properly engage in the corners of the highwood post as shown in Figure 5 below. ®...
- Page 4 Enjoy your Pottsville corner fence! Other Highwood items you may be interested in. Visit our Website and Facebook page to see more highwood products! ® www.highwood-usa.com • www.facebook.com/highwoodUSA...
Need help?
Do you have a question about the Pottsville and is the answer not in the manual?
Questions and answers