Advertisement
Quick Links
SOLARFLEX 600i-L BASIC
TROUBLESHOOTING GUIDE
BEFORE STARTING:
• Verify proper system set up from SF 600i-L Quick Start Guide at www.keystonerv.com
• Is the 12 Volt Battery Disconnect for the unit turned on? Found near entry door on interior wall or in
exterior front storage compartments.
• Is the solar panel, clean, in direct sunlight, free from obstructions/debris?
» Clean with water and a cloth/sponge
THE VICTRON APP DOES NOT RESPOND ON MY SMART DEVICE:
• Bluetooth is off
» Turn on Bluetooth, close and restart app
• Outside Bluetooth range of the solar controller
» Move within a few feet of the solar controller
I AM UNABLE TO SELECT THE CONTROLLER OR THE
SHUNT
FROM THE DEVICE LIST ON MY SMART DEVICE
(NOT ACTIVE OR HIGHLIGHTED):
Another device is already connected to the APP and only one device can
be connected at a time
APP INDICATES AN UPDATE TO FIRMWARE IS NEEDED:
• Allow the update
SMART SOLAR WATTS, VOLTAGE AND CURRENT ALL
READ "0" ON THE VICTRON CONNECT APP:
• No power to Charge controller (found in front compartment or pass through)
» Verify the 10 gauge (+) and (–) wires from the solar panel are tight and properly connected to the
(+) and (–) connections labeled "PV"
• Solar Panel not connected to the roof port
» Connect the Solar Panel to the roof port
VICTRON CONNECT APP
IF BATTERY VOLTAGE READS
"0" VOLTS, CHECK FOR POOR
CONNECTION TO BATTERY.
USER MANUAL
In partnership with
Advertisement
Summary of Contents for Keystone SOLARFLEX 600i-L
- Page 1 SOLARFLEX 600i-L BASIC TROUBLESHOOTING GUIDE BEFORE STARTING: • Verify proper system set up from SF 600i-L Quick Start Guide at www.keystonerv.com • Is the 12 Volt Battery Disconnect for the unit turned on? Found near entry door on interior wall or in exterior front storage compartments.
- Page 2 SOLARFLEX 600i-L BASIC TROUBLESHOOTING GUIDE PASSWORD DOES NOT ALLOW ACCESS TO VICTRON APP: • Log in with factory Default pin code 000000 to set new password. • If the pin code is unknown or forgotten for the Smart Controller or the Smart Shunt the pin can be reset.
- Page 3 SOLARFLEX 600i-L BASIC TROUBLESHOOTING GUIDE I LOST ALL 12V POWER • Ensure the 12V unit battery disconnect black switch is on, located on interior wall near entrance door or in front storage compartment. • The 12V unit battery disconnect is equipped with a Battery Guard Auto that is designed to disconnect the 12V battery system if the battery’s state of charge voltage drops below 11.5 volts for 2 minutes or more.