Advertisement
Inserting Battery
Ensure that the battery polarity is correct, insert the battery and place in the housing
Tighten the battery cover clockwise in the direction of the lock arrow
If the pinpointer is not used for an extended period of time, remove the battery
Operating the Pinpointer
Rotate the sensitivity dial clockwise to turn on the pinpointer. The pinpointer will switch
on and the buzzer / LED / vibration mode will activate
Rotate the sensitivity dial until the pinpointer reaches a point where a constant signal is
produced. From this point rotate the dial counter-clockwise until no signal is produced.
This is when the pinpointer is ready to detect.
Properly adjusting the pinpointer sensitivity will provide optimum performance when
locating objects -- take your time to set accordingly (different regions / ground surfaces /
detecting locations may require different sensitivity levels).
Use the pinpointer by touching the objects in your dig area with the probe. If a signal is
produced then this may be the metallic object's signature. The pinpointer responds by
recognizing the object by omitting a buzzer / LED / vibration.
CAUTION
The probe pinpointer tip is waterproof and can be submerged in water. The handle is not
waterproof and therefore should not be submerged in water
If an irregular signal is produced by the pinpointer, the sensitivity may be set to high.
Turn the sensitivity dial counter-clockwise to reduce the sensitivity
If the pinpointer is turned on and produces no signal or has a dim LED, the battery may
require changing
Remove batteries from pinpointer if it is not to be used for an extended period of time.
At the end of the battery's serviceable life, this product should not be treated as
household or general waste. It should be handed over to the applicable collection point
for the recycling of electrical and electronics equipment, or returned to the supplier for
disposal. Please dispose of carefully and accordingly.
Fig.2
Advertisement
