Configuring The At&T Netgate 8200; Access The At&T Netgate Web Interface - AT&T NetGate 8200 Installation Manual

Configuring the AT&T NetGate 8200
In most cases, no user-level configuration is required as an IP
address is retrieved automatically through DHCP and the device
configuration is retrieved from the network. In some cases it is
necessary to perform some initial configuration through the Web
Interface – for example if the primary Internet connection needs to be
manually configured prior to use.
Access the AT&T NetGate Web Interface
The AT&T NetGate web interface can be accessed from a computer
attached to a LAN port on the AT&T NetGate. The web interface can
be used to access various administration functions and can allow the
VPN connection to be controlled.
1. Open your browser (Supported browsers are Microsoft Internet
Explorer® version 5.0 or higher, Netscape Navigator® version
6.2 or higher and Mozilla Firefox v1.5 or higher).
2. In the Address or Location box enter
http://netgate.att.com and press the Enter key.
3. This will take you to one of several possible initial pages,
depending on your configuration and connectivity options.
Common navigation icons appear on the upper left side of each
page for access to "Home", "Control Panel" and "Help"
In the event that the AT&T NetGate has already retrieved its
configuration, it may have been configured for Administrator access.
See Administrator Access on page 15 for more information on
gaining administrator access to the web interface.
8