Advertisement
3.
Place the templates onto the top of the barrel/
container lid.
• The in-feed and out-feed ports are marked on
the template, make sure these are facing in
opposite directions.
• Make sure there is a 2" space between the edge of the
lid and the template drawing. See Figure 4.
• Tape the two templates to the top of the barrel/container
lid and trace the inner circle with a marker onto the lid.
4.
Mark the direction of the in-feed and out-feed on to the
barrel/container lid with an arrow.
Figure 2
5.
Leave the templates in place and drill the four holes in
each template. Remove the templates.
Figure 3
6.
Use a jigsaw or suitable cutting tool to cut the holes in the
barrel/container lid. NOTE: Drilling a pilot hole may help
create a better staring point.
7.
Secure the 4" ports and in-feed/out-feed elbows to the
barrel/container lid.
• The ports are installed to the top of the lid and the
elbows to the bottom so they will be on the inside of the
barrel/container.
• Make sure the in-feed/out-feed elbows are facing the
opposite directions, as shown in Figures 4 and 5.
• There are two sets of hardware supplies, use the
correct hardware for the barrel/container lid. The longer
bolts and nuts are for thick lids and the shorter bolts
and nuts are for thin lids.
Figure 4
8.
Place the lid onto the barrel or container and attach and
secure the dust collection hoses and hook-ups to the dust
collections system and machine being used.
NOTE: When the dust collection system is turned on the debris
is pulled into the barrel/container and separated, the heavier
wood chips fall to the bottom and the lighter dust particles are
pulled into the dust collection system as shown in Figure 5.
Figure 5
Out-Feed
Elbow
Hose
to Dust
Collection
System
Southern Technologies, LLC
Waukegan, IL 60087
4" Turn Key Hose
4" Port
Clamps
4" Port
In-Feed
Elbow
Hose to
Machine
Advertisement
