Advertisement
Quick Links
AIR SUPPLY REQUIREMENTS
1.
Supply tool with 90 psig (6.2 bar) of clean, dry air. Higher pressure drasti-
cally reduces tool life.
2.
Connect tool to air line using pipe, hose and fitting sizes shown in the dia-
gram on page 12.
3.
Do not install a quick coupler directly into the grinder throttle handle.
4.
Minimum compressor requirement: 3hp (2238 w), 60 gal. air tank.
LUBRICATION
Use an air line lubricator with SAE #10 oil, adjusted to two drops per
minute. If an air line lubricator cannot be used, add air motor oil to the inlet
once a day.
NOISE & VIBRATION DECLARATION
Sound pressure level 90 dB(A) in accordance with Pneurop 8N-1. For
sound power, add 10 dB(A).
Vibration value 3.0 m/s 2 , re. ISO 8662-1.
MAINTENANCE
1.
Disassemble and inspect air motor every three months if the tool is used
every day. Replace damaged or worn parts.
2.
High wear parts are underlined in the parts list.
*
These declared values were obtained by laboratory type testing in compliance with the stated standards
and are not adequate for use in risk assessments. Values measured in individual work places may be high-
er than the declared values. The actual exposure values and risk of harm experienced by an individual
use
are unique and depend upon the way the user works, the workpiece and the workstation design, as
r
well as upon the exposure time and the physical condition of the user. We, cannot be held liable for the
consequences of using the declared values, instead of values reflecting the actual exposure, in an indi-
vidual risk assessment in a work place situation over which we have no control.
! WARNING
To reduce risk of injury, everyone using, installing, repairing, maintaining, chang-
ing accessories on, or working near this tool must read and understand these
1375 Hird Ave., Cleveland, OH 44107 • Phone (216) 521-8567 • Fax Local 521-9476 / USA & Canada (800) 344-9191
E-Mail: sales@martindaleco.com • Website: www.martindaleco.com
MODEL M-12 AIR GRINDER
INSTRUCTIONS
*
SAFETY INSTRUCTIONS
Advertisement
Summary of Contents for MARTINDALE M-12
- Page 1 MODEL M-12 AIR GRINDER INSTRUCTIONS AIR SUPPLY REQUIREMENTS Supply tool with 90 psig (6.2 bar) of clean, dry air. Higher pressure drasti- cally reduces tool life. Connect tool to air line using pipe, hose and fitting sizes shown in the dia- gram on page 12.
-
Page 2: Entanglement Hazards
instructions before performing any such task. Our goal is to produce tools that help you work safely and efficiently. The most important safety device for this or any tool is YOU. Your care and good judgment are the best protection against injury. All possible hazards cannot be covered here, but we have tried to highlight some of the important ones. -
Page 3: Operating Hazards
Scalping can occur if hair is not kept away from tool and accessories. Choking can occur if neckwear is not kept away from tool and accessories. OPERATING HAZARDS Never mount a grinding wheel, cut off wheel or routter cutter on a die grinder or tire buffer. -
Page 4: Workplace Hazards
WORKPLACE HAZARDS Slip/Trip/Fall is a major cause of serious injury or death. Be aware of excess hose left on the walking or work surface. High sound levels can cause permanent hearing loss. Use hearing protec- tion as recommended by your employer or OSHA regulation (see 29 CFR part 1910). - Page 5 1375 Hird Ave., Cleveland, OH 44107 • Phone (216) 521-8567 • Fax Local 521-9476 / USA & Canada (800) 344-9191 E-Mail: sales@martindaleco.com • Website: www.martindaleco.com...