Advertisement
Quick Links
Technical Support Sheet - Installation & Maintenance Instructions
Smarterwater
Stormwater Manhole Sensor
This document provides step by step installation and maintenance guidance for
the Hynds Smarterwater
Contents
1. Safety Considerations ................................................... 2
2. Installation Instructions ................................................ 2
3. Maintenance Instructions ............................................. 7
®
Stormwater Manhole Sensor.
®
Disclaimer: While every effort has been made to ensure that the information in this document is correct and
accurate, users of Hynds product or information within this document must make their own assessment of
suitability for their particular application. Product dimensions are nominal only, and should be veri ed if
critical to a particular installation. No warranty is either expressed, implied, or statutory made by Hynds
unless expressly stated in any sale and purchase agreement entered into between Hynds and the user.
Scan for more
information
TSS S1.2IMI
Version: 1.0
December 2021
Advertisement
Related Manuals for Hynds Smarterwater Stormwater Manhole Sensor
Summary of Contents for Hynds Smarterwater Stormwater Manhole Sensor
- Page 1 Disclaimer: While every effort has been made to ensure that the information in this document is correct and accurate, users of Hynds product or information within this document must make their own assessment of suitability for their particular application. Product dimensions are nominal only, and should be veri ed if critical to a particular installation.
- Page 2 1. Safety Considerations The Hynds Smarterwater Stormwater Manhole Sensor can be installed in stormwater system where requires water level ® measurement. The hazards while installing or maintaining this product can include but are not limited to the presence of dangerous and explosive gases, confined spaces and fall risks. The user should follow their organisation’s safety policies and ensure all safety procedures are adhered to when installing and performing maintenance of the device.
- Page 3 Isolate the working zone Remove manhole cover by using lid lifter and place the manhole cover aside in a safe working area. Ensure the area is safe from hazards in accordance with your organisation’s safety operating procedures. For example, hazard identification and relevant testing may be required.
- Page 4 While holding the antenna with the Hynds antenna spanner. Install and tighten the nut to a minimum of 75Nm. Special precautions when attaching the antenna to...
- Page 5 Thread the antenna cable through the center hole of the unit and slide the brain onto the stem (ensure the key and groove are in the correct position). Connect the gold plated connector to the bulkhead fitting on the housing. Once in place, use the tool provided to tighten the connector, although this can also be done by hand.
- Page 6 Install the washer and nut to secure the brain to the manhole lid, then insert the safety pin. Turn ON the device using key provided. The key must be inserted for at least 2-3 seconds to allow for the unit to be activated. A series of beeps will confirm the status of the unit: Turn ON indication: Two long beeps ■...
- Page 7 Any unauthorised action that may lead to potential damage to the unit is at the operator’s risk. Hynds can supply spare parts including antenna dome, magnet key, nuts, washers, and the entire unit.
- Page 8 Disclaimer: While every effort has been made to ensure that the information in this document is correct and accurate, users of Hynds product or information within this document must make their own assessment of suitability for their particular application. Product dimensions are nominal only, and should be veri ed if critical to a particular installation.
Need help?
Do you have a question about the Smarterwater Stormwater Manhole Sensor and is the answer not in the manual?
Questions and answers