MO BELLA MONUMENT COLUMN Assembly Manual

1
L-Connector Bar
5
Short Bar with Velcro
4 pc
7
80ct Bag of Lights*
2 pc
YOU WILL NEED: Ladder(s), hammer, screwdriver
*If the Bella Monument is being ordered with the Lit Bella Insert, these lights will be included with that product.
While assembly is possible with one person, due to the size of the sign, two people is highly recommended
and three is preferred for easy assembly and installation.
These steps show assembly around a structural column. If the Bella Monument is going to be freestanding, being used
with the separate Lit Bella Insert, or if you wish the graphic to be unlit, skip Step 1 and follow the remaining steps.
STEP 1
7
Peel o the adhesive backs of the lights
them to the structural column in a spiral pattern.
STEP 2
1
5
Place two short bars on opposite sides of the column
5
with the velcro facing inward. Next, with the velcro
sides again facing inward, insert an L-connector bar
into the ends of one side of the short bars and an
L-connector bar with velcro
into the other ends of
2
the short bars to complete the base.
ASSEMBLY GUIDE
BELLA MONUMENT COLUMN
2
L-Connector Bar w/Velcro End
2 pc
6
Long Bar
8
Long Bar with Threaded Rod
ASSEMBLY INSTRUCTIONS
STEP 3
8
as you attach
7
5
2
1
Insert the open end of the four long bars with
threaded rods
threaded rods should be facing upward.
PARTS LIST
3
Middle Bar
2 pc
8
into the base connectors. The
8
4
4 pc
4 pc
Graphic
4 pc
STEP 4
3
On opposite sides of the column, thread the rods of
the long bars through the ends of two middle bars
making sure the bar's curve is facing inward.
1 pc
3
,
3