Page 1
Please read this guide carefully and check that you have all parts before you begin assembly. TWO PEOPLE RECOMMENDED General Care: Keep furniture out of direct sunlight. Use mats and coasters to protect surfaces. Do not place hot or wet items directly onto unprotected surfaces. Cleaning: Wipe surfaces with a clean damp (not wet) cloth then dry with a clean lint free cotton cloth.
SCREWS LIST PART QTY. ITEM PART QTY. ITEM 3X15 MM 4X20 MM 6X40 MM 6X30 MM 4X14 MM Φ15 MM 6X35 MM 8X30 MM 6X12 MM 6X115 MM 6X40 MM 4X35 MM 6X4 0MM BOLT INSTALL ATI ON AS BEL OW: Bolt Connecting piece Rotate connecting piece if found...
ASSEMBLY STEPS: SCREWS 3X15 MM SCREWS 3X15 MM SCREWS 6X12 MM...
Page 6
SCREWS 4X35 MM Right Right Left Left SCREWS 3X15 MM SCREWS 4X20 MM...
Page 7
SCREWS 3X15 MM SCREWS SCREWS 3X15 MM 6X12 MM SCREWS Be careful not to overtighten the metal 4X35 MM rod or you will damage the drawer front.
Page 8
move the lock lever on the inner rail as shown and separate the outer rail (34a) and inner rail (34b) from the 2 file drawer slides (34) SCREWS SCREWS 3X15 MM 4X20 MM Tighten the metal plates on the marked position of the metal bar...
Page 9
SCREWS 3X15 MM Right Left SCREWS 3X15 MM 8X30 MM SCREWS 6X40 MM SCREWS Φ15 MM 3X15 MM...
Page 10
P.10 10mm 19mm 19mm 10mm SCREWS 6X40 MM SCREWS Φ15 MM 6X30 MM...
Page 11
P.11 SCREWS 6X35 MM ** There are 2 options to assemble our desk, please choose it according to your preference. A -A7 B1-B7...
Page 12
P.12 SCREWS 6X12 MM SCREWS 6X35 MM 6X12 MM SCREWS 6X40 MM...
Page 13
P.13 SCREWS 6X35 MM 6X115 MM SCREWS 4X14 MM...
Page 14
P.14 Inner silver ball bearing slide Keeping both runner slides fully Ensure the ball bearing glider extended, align the drawer is positioned at the front runners and then slide drawer all against the plastic end stop the way into the closed position applying a little force if required.
Page 15
P.15 SCREWS 6X12 MM SCREWS 6X35 MM 6X12 MM SCREWS 6X40 MM...
Page 16
P.16 SCREWS 6X35 MM 6X115 MM SCREWS 4X14 MM...
Page 17
P.17 Inner silver ball bearing slide Keeping both runner slides fully Ensure the ball bearing glider extended, align the drawer is positioned at the front runners and then slide drawer all against the plastic end stop the way into the closed position applying a little force if required.
Need help?
Do you have a question about the PC28 and is the answer not in the manual?
Questions and answers