Connecting The Scsi Cable; Setting The Scsi Id And Terminator - Canon DR-7580 Instructions Manual

Chapter 2 Preparation Before Use

◆ Connecting the SCSI Cable

■ Before you connect the SCSI cable, make sure that the scanner and the computer
are turned OFF.
CAUTION
■ Do not connect both SCSI and USB interface cables at the same time.
Connect your computer to the scanner using the SCSI cable.
Two SCSI connectors are located on the rear of the scanner. Insert the SCSI
cable from the computer into one of the connectors on the bottom of the scanner.
To connect another SCSI device to the computer, insert the other SCSI cable into
the vacant SCSI connector on the rear of the scanner, and connect the other end
of the SCSI cable into the SCSI device in a daisy chain.
SCSI Cable

◆ Setting the SCSI ID and Terminator

Set the SCSI ID and the terminator on the DIP switches located between the
SCSI connectors and the power cord connector.
Move the DIP switch towards you to turn it OFF and move it towards the scanner
to turn it ON.
SCSI ID switch
Set the SCSI ID referring to the table above.
Set unique SCSI IDs to any other built-in SCSI devices or SCSI devices
connected to the computer.
20
USB Connector
(cannot be connected)
Terminator ON/OFF switch
SCSI Connectors Power Cord Connector
SCSI ID SW1
0 OFF
1 ON
2 OFF
3 ON
4 OFF
5 ON
6 OFF
7 ON
SW2 SW3
OFF OFF
OFF OFF
ON OFF
ON OFF
OFF ON
OFF ON
ON ON
ON ON