Advertisement
3. Using the two marked locations, drill holes into
the grout line approximately 1" (2.5 cm) deep.
4. Insert wall anchors into drilled holes.
5. Tap anchors lightly with hammer until the anchor
is flush with the tile or grout.
6. Place wall bracket onto the wall aligning the
bracket holes with the wall anchors. Make sure
hook is in the upward position.
7. Screw stainless steel screws through holes in wall
bracket and into center of wall anchors. Make
sure the screws are tight and that the wall bracket
is held tightly against the wall.
8. To attach base to bracket, fit slot over bracket
hook and snap down into place.
USING THE SCOOP
To attach the scoop to the base, simply fit slot over
hook and hang in place. To remove scoop, lift up
then off the hook.
CLEANING & CARE
Remove Bug Pod base from the wall bracket by first
holding the bracket securely in place on the wall, then
pulling the base up and off the bracket hook. Clean
base and scoop with warm water and mild soap.
© 2014 BKD (A DIVISION OF TOMY)
1241 W WARNER RD, SUITE 101
TEMPE, AZ, USA 85284
FOR US CUSTOMERS: 888.376.4763
BOONINC.COM
PATENTED, U.S. PATENT NO.
Patents, trademarks and copyrights are exclusively owned by BKD.
Made in China.
B453-02-INT-002
Advertisement
