DRSR483GDCC/WW – GE
Dryer Dimensions (in inches)
Power Cord Locations
Specification Created 6/03
Super 7.0 Cu. Ft. Capacity Gas Dryer with Stainless Steel Drum
*24-1/2" from the edge of the side panel to the front.
25-1/2" from front to edge of endcaps.
When viewed from the front of the unit, exhaust 3-way via rear, left and
bottom. Dryer is shipped exhausted to the rear. Alternate exhausting
knockouts are supplied.
Gas: An individual properly-grounded branch circuit, with a three-prong
grounding-type receptacle, protected by a 15 or 20 amp circuit breaker or
a time-delay fuse is required.
Gas Dryer Electric Rating: 120V, 60Hz, 6A
Gas (BTU/HR): 22,000. Factory-equipped for natural gas. Tested for LP
gas. LP gas supply requires a conversion kit. Check installation instructions
for correct kit and have a qualified gas technician install a conversion kit.
See dryer ducting information for proper installation.
Note: Dryer wall outlet must be located within 36" of service cord entry
and accessible when dryer is mounted in position.
Installation Information: For complete information, see installation
instructions packed with your dryer.
For answers to your Monogram,
appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center